Abstract:Considering economic and environmental factors, incorporating rubber into calcareous sand as a backfill material in marine engineering construction is a favorable approach. The research on rubber-modified sand has been extensive in the past, but it has not been fully understood. There is a need for a comparative study between impact loads and static loads. This study employs cyclic impact breakage tests and triaxial compression breakage tests to investigate the inhibitory influence of rubber on particle breakage and the Impact on the Volumetric Deformation of calcareous sand under distinct loading conditions. The experimental results indicate that under impact loading, as the impact energy increases, the relative breakage rate of calcareous sand increases, but the rate of increase gradually decreases. The addition of rubber up to a content of 10% notably suppresses calcareous sand breakage, while the impact of a rubber content between 10% and 20% on breakage is weaker. A higher rubber content results in a reduced sensitivity of sample breakage, which may be related to the coordination number of the calcareous sand and rubber. Under the final impact energy, a lower rubber content leads to a greater volumetric deformation of samples, while this trend reverses during the early loading stages due to the superior deformability of rubber. Furthermore, the dependency of calcareous sand particle breakage on volumetric deformation gradually decreases with increasing rubber content. Unlike under impact loading, under triaxial compression loading, along with the increase in input energy, the relative breakage rate of calcareous sand shows continuous growth, and its rate of increase progressively intensifies, which is related to the decreasing degree of participation of rubber. During the consolidation deformation phase, a linear correlation emerges between the input energy and deformation for rubber-modified samples, referred to as the consolidation deformation curve. In the compression phase, a positive linear correlation between volumetric deformation and input energy is observed. The findings of this study offer certain theoretical guidance for understanding the breakage and deformation patterns of rubber-modified calcareous sand in engineering applications.

Experimental study on the Influence of Load on Permeability Coefficient of Calcareous Sand

Micro-and macro-mechanical behavior of crushable calcareous sand in South China Sea

Dynamic mechanical response and particle breakage characteristics of calcareous sand

Analysis of Damage and Permeability Evolution of Sandstone under Compression Deformation

Experimental investigation on mechanical behavior and particle crushing of calcareous sand retrieved from South China Sea

Three-dimensional pore characteristics and permeability properties of calcareous sand with different particle sizes

Effects of Particle Breakage on the Mechanical Behavior of Calcareous Sand Under Confined Compression Tests

Experimental study on the mechanical behaviors and particle breakage characteristics of calcareous sand from South China Sea under repeated one-dimensional impacts

Experimental study of the mechanical behavior of calcareous sand under repeated loading-unloading

Experimental study on mechanical behavior and permeability evolution of weakly cemented sandstone under unloading conditions

Experimental Study on the Mechanical Strength, Deformation Behavior and Infiltration Characteristics of Coral Sand

Study on the inhibitory effect of rubber on particle breakage and the impact on the volumetric deformation of calcareous sand under different loading modes

Mechanical behavior and particle breakage of calcareous sand in triaxial test

Experimental and numerical study on the fragmentation mechanism of a single calcareous sand particle under normal compression

The role of incremental stress ratio in mechanical behavior and particle breakage of calcareous sand

Experimental Study on the Impact of Water Content on the Strength Parameters of Coral Gravelly Sand

Microscopic study of the impact of particle morphology on the compressibility of calcareous sands

Experimental study on the effects of water content on the compression characteristics and particle breakage of calcareous sand

STUDY ON CRUSHING PROCESS AND MICROSCOPIC MECHANISM OF CALCAREOUS SAND

Investigation on the Confined Breakage Characteristics of Calcareous Sand in the South China Sea Integrated Using Relative Breakage Ratio and Fractal Dimension

Experimental Study on the Time-Dependent Oedometric Compression Behavior of Calcareous Sand