Dynamic Characteristics of Elastic Ring Squeeze Film Damper Oscillated by Bearing Contact Force
Xiaomin Yang,Bingzhen Jiang,Yan Li,Qiang Zhao,Sier Deng
DOI: https://doi.org/10.1007/s42417-023-00851-6
2023-03-13
Journal of Vibration Engineering & Technologies
Abstract:PurposeElastic Ring Squeeze Film Damper (ERSFD) is normally incorporated into high-speed ball bearings to attenuate the vibration amplitude of the rotor system in aero-engines. At high rotor speeds, the bearing introduces considerable nonlinear excitation to the journal, causing it to exhibit distinct dynamic properties. As well, the deformation of the elastic ring in the ERSFD model significantly influences the hydrodynamic reaction force on the journal. This paper develops a high-speed ball-bearing excited ERSFD model with the deformation of the elastic ring analytically formulated. The effects of rotor operating speed and squirrel cage stiffness on the transient and steady-state dynamics of the journal were examined.MethodsThe journal is modeled under the excitation of ball-outer raceway interaction rather than rotor unbalance force, emphasizing heavy thrust-applied load. Ball-outer raceway interaction is calculated using a modified quasi-static model. Elastic ring deformation is derived analytically through a thin-walled ring and the oil film pressure is governed by the generalized Reynolds equation. Runge–Kutta approach was used to numerically integrate the differential equations of motion, and the journal center orbit and vibration acceleration were experimentally measured.ResultsThe results show that as the squirrel cage stiffness increases by 1.23 times from 0.6855, the eccentricity and transmissibility for the ERSFD with bearings are increased by a factor of 1.8 and 3, respectively. Correspondingly, the values for the ERSFD without bearings are increased by a factor of 1.7 and 2.7. As the rotor operating speed increases by 1.75 times from 8000 r min−1, the eccentricity and transmissibility for the ERSFD with bearings are decreased by 28.6% and 54.6%, respectively; for the ERSFD without bearings, the eccentricity remains unchanged and the transmissibility is decreased by 26.2%.ConclusionIt was concluded that when the journal works at a steady state an increase in squirrel cage stiffness disadvantages attenuation in bearing excitation; adequately high rotor operating speeds benefit journal dynamics when bearing excitation is considered in ERSFD. At transient state, lower squirrel cage stiffness and higher rotor operating speed allow the journal to behave in stable periodic motion for the ERSFD with bearing excitation; however, for the ERSFD without bearing excitation, lower squirrel cage stiffness fails to make the journal whirl periodically, and the rotor operating speed has little effect on the transient dynamics of the journal.
engineering, mechanical,mechanics