Abstract:The fabrication of polymeric micro/nanofibers is gaining attention due to their use in an array of applications including tissue engineering scaffolds, nanosensors, and fiber-reinforced composites. Despite their versatile nature, polymeric fibers are widely underutilized due to the lack of reliable, large-scale production techniques. Upon the discovery of centrifugal spinning and, recently, pressurized gyration techniques, new research directions have emerged. Here, we report a comprehensive study detailing the optimal conditions to significantly improve the morphology, homogeneity, and yield of fibers of varying diameters. A series of polymeric fibers was created using a 21 wt. % solution of polyethylene oxide in distilled water and the fluid behavior was monitored inside a transparent reservoir using a high-speed camera. Fabrication of the fibers took less than 1 s. Using centrifugal spinning, we studied the formation of the fibers at three different rotational speeds, and for pressurized gyration, one rotational speed was studied with three different nitrogen gas pressures. Using the pressurized gyration technique at a gas pressure of 0.3 MPa, there was significant improvement in the production yield of the fibers. We found a strong correlation between the variation of pressure and the rate of the solution leaving the reservoir with the improved morphology of the fibers. The use of reduced power techniques, like centrifugal spinning and pressured gyration, to yield high-quality nonwoven nanofibers and microfibers in large quantities is important due to their use in rapidly expanding markets.

Rheologic behaviors and continuously dry spinning of polyacetylacetonatozirconium fibers

Effect of hyperbranched poly(ester amine) additive on electrospinning of low concentration poly(methyl methacrylate) solutions

Microstructural Evolution during Dry-Jet Wet Spinning Postprocessing from Coagulation Bath Fiber to High-Performance Polyacrylonitrile Precursor Fiber

Preparation of High-Quality Polyacrylonitrile Precursors for Carbon Fibers Through a High Drawing Ratio in the Coagulation Bath During a Dry-Jet Wet Spinning Process

IMPROVEMENT OF POLY(METHYL METHACRYLATE) ELECTROSPUN FIBER UNIFORMITY BY ADDITION OF POLY(ESTER AMINE)

Fabrication of High‐Strength Continuous Zirconia Fibers and Their Formation Mechanism Study

Spinning solution flow model in the nozzle and experimental study of nanofibers fabrication via high speed centrifugal spinning

Effect of Coagulation Bath Concentration on the Structure and Properties of Polyacrylonitrile As-Spun Fibers During Wet-Spinning

Non-Coagulant Spinning of High-Strength Fibers from Homоpolymer Polyacrylonitrile Synthesized via Anionic Polymerisation

Fabrication of Continuous Aligned Polyvinylpyrrolidone Fibers Via Electrospinning by Elimination of the Jet Bending Instability

Preparation and Application of Spinnable Zirconium Sol I.Preparation of Continuous Zirconia Fiber

Draw-Spinning of Kilometer-Long and Highly Stretchable Polymer Submicrometer Fibers.

Numerical Study of Melt-Spinning Dynamic Parameters and Microstructure Development with Ongoing Crystallization

Experimental and theoretical investigation of the fluid behavior during polymeric fiber formation with and without pressure

Dry Spinning Approach to Continuous Graphene Fibers with High Toughness

Dissipative particle dynamics simulations of centrifugal melt electrospinning

Effect of Heat-treatment Atmosphere on Preparation of Continuous Zirconia Fibers

Enhancing Gel Spinning of Ultra-High Molecular Weight Polyethylene: Insights into Rheology and Microstructure

Study on the spinnability and mechanical properties of aspirator aided melt‐spun binary blends polypropylene fibers

Dry Spin Graphene Oxide Fibers: Mechanical/Electrical Properties and Microstructure Evolution

Optimization of hot drawing process of ultra‐high molecular weight polyethylene monofilament prepared by melt spinning