Abstract:Defects introduced during additive manufacturing currently control fatigue resistance and lead to a large scatter in lifetime, with pancake shaped lack of fusion (LOF) defects being particularly potent. In this study the fatigue crack propagation life of selective laser-melted (SLM) AlSi10Mg alloy is considered in cases where single cracks and multiple cracks can initiate from LOF defects under high cycle fatigue (HCF). Firstly, the aspect ratios of initially long fatigue cracks were determined for critical LOF defects obtained from X-ray CT renderings using the critical defect regularization method, and the response surface method used to obtain the stress intensity factor of the crack front quickly and continuously. Then a single crack propagation model considering the evolution of the crack aspect ratio established to predict the crack propagation life which is in good agreement within in situ X-ray CT imaging of the crack front when a single crack is dominant. The crack propagation phase was predicted to represent 35–60% of the total fatigue life representing a larger fraction at high stress amplitudes. Multiple cracks were found to initiate cracks at the larger stress amplitudes. In cases where multiple cracks arise this is non-conservative and so a synergistic multiple fatigue crack growth (smFCG) model was developed based on multiple defects measured a priori by X-ray CT to depict the competitive cracking effect. Compared with the single crack model, the smFCG model predicts a shorter propagation life (by 5–10%) when multiple defects are involved since it considers all the initial defects within the crack initiation region. Given the propensity of large numbers of defects in AM material this approach may be more appropriate in many cases.

In situ synchrotron ultrasonic fatigue testing device for 3D characterisation of internal crack initiation and growth

In situ 3D characterization of high temperature fatigue damage mechanisms in a cast aluminum alloy using synchrotron X-ray tomography

Nde Of Small 3-D Surface Fatigue Cracks In Metals By Microwaves

A Method for Sizing Small Fatigue Cracks in Stainless Steel Using Microwaves

Three-dimensional Quantitative in Situ Study of Crack Initiation and Propagation in AA 6061 Aluminum Alloy Sheets Via Synchrotron Laminography and Finite-Element Simulations

A Method of Sizing Small Fatigue Crack in Stainless Steel by Microwaves(NDE4)

Investigation of the mechanical work during ultrasonic fatigue loading using pulsed time-resolved X-ray diffraction

In situ tomographic study of a 3D-woven SiC/SiC composite part subjected to severe thermo-mechanical loads

Novel method for in situ damage monitoring during ultrasonic fatigue testing by the advanced acoustic emission technique

Characterization of internal fatigue cracks in aluminum alloys by simulation of phase contrast tomography

3D characterization and modeling of low cycle fatigue damage mechanisms at high temperature in a cast aluminum alloy

3D characterization of closure of surface and internal fatigue cracks in nodular cast iron using Digital Volume Correlation of laboratory X-ray tomography images

Fatigue and Fracture of Small Cracks in Superelastic Nitinol

In-situ X-ray Microscopy of Crack-Propagation to Study Fracture Mechanics of On-Chip Interconnect Structures

Identifying fatigue crack initiation through analytical calculation of temporal compliance calibrated with Computed Tomography

Three-Dimensional in Situ XCT Characterisation and FE Modelling of Cracking in Concrete

Crystallographic analysis for fatigue small crack growth behaviors of a nickel-based single crystal by in situ SEM observation

In situ SEM-DIC technique and its application to characterize the high-temperature fatigue crack closure effect

Fatigue Crack Length Sizing Using a Novel Flexible Eddy Current Sensor Array

In situ X-ray imaging of fatigue crack growth from multiple defects in additively manufactured AlSi10Mg alloy

In-situ investigation of fatigue crack growth behavior of 34CrNi3Mo high-strength steel