Application of DInSAR-PSI Technology for Deformation Monitoring of the Mosul Dam, Iraq

Arsalan Ahmed Othman,Ahmed F. Al- Maamar,Diary Ali Mohammed Al-Manmi,Veraldo Liesenberg,Syed E. Hasan,Younus I. Al-Saady,Ahmed T. Shihab,Kareem Khwedim
DOI: https://doi.org/10.3390/rs11222632
IF: 5
2019-11-11
Remote Sensing
Abstract:On-going monitoring of deformation of dams is critical to assure their safe and efficient operation. Traditional monitoring methods, based on in-situ sensors measurements on the dam, have some limitations in spatial coverage, observation frequency, and cost. This paper describes the potential use of Synthetic Aperture Radar (SAR) scenes from Sentinel-1A for characterizing deformations at the Mosul Dam (MD) in NW Iraq. Seventy-eight Single Look Complex (SLC) scenes in ascending geometry from the Sentinel-1A scenes, acquired from 03 October 2014 to 27 June 2019, and 96 points within the MD structure, were selected to determine the deformation rate using persistent scatterer interferometry (PSI). Maximum deformation velocity was found to be about 7.4 mm·yr−1 at a longitudinal subsidence area extending over a length of 222 m along the dam axis. The mean subsidence velocity in this area is about 6.27 mm·yr−1 and lies in the center of MD. Subsidence rate shows an inverse relationship with the reservoir water level. It also shows a strong correlation with grouting episodes. Variations in the deformation rate within the same year are most probably due to increased hydrostatic stress which was caused by water storage in the dam that resulted in an increase in solubility of gypsum beds, creating voids and localized collapses underneath the dam. PSI information derived from Sentinel-1A proved to be a good tool for monitoring dam deformation with good accuracy, yielding results that can be used in engineering applications and also risk management.
environmental sciences,imaging science & photographic technology,remote sensing,geosciences, multidisciplinary
What problem does this paper attempt to address?
The key problem that this paper attempts to solve is to ensure the safe and efficient operation of the Mosul Dam and safeguard its structural integrity by monitoring its deformation. Specifically, the paper focuses on the following issues: 1. **Limitations of traditional monitoring methods**: Traditional monitoring methods based on on - site sensor measurements have certain limitations in terms of spatial coverage, observation frequency, and cost. 2. **Using DInSAR - PSI technology for deformation monitoring**: The paper explores how to use differential interferometric synthetic aperture radar (DInSAR) and permanent scatterer interferometry (PSI) techniques in synthetic aperture radar (SAR) images to characterize the deformation of the Mosul Dam. This method can provide high - precision millimeter - level deformation monitoring and overcome the shortcomings of traditional methods. 3. **Relationship between dam deformation and geological factors**: The paper studies the relationship between the dam deformation rate and reservoir water level, grouting activities, and the dissolution of underground gypsum layers. In particular, the gypsum layer beneath the dam has formed cavities and local collapses due to dissolution, resulting in the settlement of the dam. 4. **Verifying the accuracy of remote sensing results**: To ensure the effectiveness and accuracy of the DInSAR - PSI technology, the paper compares and verifies the remote sensing analysis results with on - site global navigation satellite system (GNSS) measurement data. In summary, the main purpose of this paper is to show how to use DInSAR - PSI technology to conduct high - precision deformation monitoring of the Mosul Dam and verify the reliability of its results, thereby providing strong support for engineering applications and risk management.