Abstract:Fiber reinforced thermoplastic polymer composites have gained a lot of attention over the past two decades, due to their excellent mechanical performance and their lightweight resulting in lower CO2 emissions for airplanes and vehicles. However, with increased demand for these materials, research regarding environmentally friendly recycling routes has become a central environmental issue. Mechanical recycling by exploiting the melting properties of thermoplastic polymers has proven an excellent way of increasing the value of recycled composites, especially compared to other mainstream techniques. This research aims at investigating the relationship between the microstructure of these materials and their resulting mechanical properties. The studied material is processed by compression molding chopped woven composites chips, made from a polyamide 6 matrix reinforced with glass fibers. A novel microstructural investigation for these types of materials was conducted using multiple destructive and non-destructive techniques, along with tensile and flexural tests on specimens made from different chips sizes. This investigation revealed a hierarchical fiber structure with a mixture of intact woven chips and randomly oriented unidirectional fiber strands. This microstructure causes complex damage propagation mechanisms and variability in mechanical performance. This hinders development and large-scale commercialization of these materials and favors other less eco-friendly recycling strategies. Therefore, developing accurate predictive models for the mechanical response of these materials is important, thus enabling fast design optimization. A multi-scale predictive model is hence proposed based on extensive qualitative and quantitative microstructural investigation and is able to capture the anisotropy of the material. This approach is validated on experimental data from a recycled PA6/Glass fiber composite and can be applied for other recycled materials in the same manner.

Characterization of carbon fibers recovered through mechanochemical-enhanced recycling of waste carbon fiber reinforced plastics

A Novel Approach on Recycling Short-Chopped Carbon Fibers by Electric Field Induced Manipulation

Study on recycled carbon fiber obtained by thermal activated oxide semiconductor and mechanical properties of its reinforced polymer composites

Recyclable separation and recovery of carbon fibers from CFRP composites: Optimization and mechanism

Efficient and Sustainable Strategy for Recycling of Carbon Fiber-Reinforced Thermoset Composite Waste at Ambient Pressure

Performance analysis of recycled carbon fiber under recycling process parameters optimized using response surface methodology

Effect of Carbon Nanofiber Distribution on Mechanical Properties of Injection-Molded Aramid-Fiber-Reinforced Polypropylene

A Study to Investigate the Mechanical Properties of Recycled Carbon Fibre/Glass Fibre-Reinforced Epoxy Composites Using a Novel Thermal Recycling Process

Recycling and repurposing of waste carbon nanofiber polymers: A critical review

Evaluation of Mechanical Properties and Pyrolysis Products of Carbon Fibers Recycled by Microwave Pyrolysis

Research on Microwave Pyrolysis Recovery and Reuse Performance of Carbon Fiber Composites

Experimental and multi-scale investigation of the mechanical behavior of mechanically recycled glass fiber reinforced thermoplastic composites

Effect of Mechanical Recycling on the Mechanical Properties of PLA-Based Natural Fiber-Reinforced Composites

Investigation of recycling effects on the mechanical properties of short carbon and glass fiber reinforced polyetherimide composites

An Experimental Study on Mechanical Behaviors of Carbon Fiber and Microwave-Assisted Pyrolysis Recycled Carbon Fiber-Reinforced Concrete

Efficient recycling of carbon fibers from amine-cured CFRP composites under facile condition

High-Efficiency Carbon Fiber Recovery Method and Characterization of Carbon FIBER-Reinforced Epoxy/4,4′-Diaminodiphenyl Sulfone Composites

Carbon-Fiber-Recycling Strategies: A Secondary Waste Stream Used for PA6,6 Thermoplastic Composite Applications

Recycling Carbon Fiber from Carbon Fiber-Reinforced Polymer and Its Reuse in Photocatalysis: A Review

Mechanical enhancement of natural-fiber-reinforced composites modified with recycled thermoset composite fillers

Melt Spinnability Comparison of Mechanically and Chemically Recycled Polyamide 6 for Plastic Waste Reuse