Abstract:Modern space programs cover a wide range of missions, including both near-earth missions and those affecting areas of deep space. In the second case, power plants based on the conversion of thermal energy into electrical energy are often considered for the power supply of spacecraft. One of the possible thermoelectric converters is the Stirling engine. To be able to design modern power plants of spacecraft built based on Stirling engines, it is necessary to use calculation tools to simulate their operation in a wide range of modes, to take into consideration the influence of subsystems on each other and the final characteristics of the power plant. As part of the work, a thermodynamic model of an external thermal circuit was created, consisting of heat pipes, heat exchangers and radiator cooler panels. The hot thermal circuit is consisted of two parts: primary and secondary, the cold thermal circuit is consisted of only one part. A mathematical model of the free-piston Stirling engine of the first order has been also implemented. The working fluid in the engine is helium. The developed models were independently debugged and then integrated into a single model of the power plant. For each type of model, the corresponding mathematical models are presented and the basic assumptions are described. The model is implemented in an open simulation environment of xcos/scilab, examples of power plant model implementation are presented. Numerical experiments were carried out to study the dynamics of the heating of the contour elements (with independent, and then with integrated modeling) and the effect of the non-stationary thermal state on the engine performance. The article presents the basic equations and the design schemes for the power plant model, as well as some results of numerical simulation, including the dynamics of hot and cold circuit temperature changes and the dynamics of changes in the indicator diagram of the engine when the external thermal circuit is heated. The developed model can be used in the early stages of spacecraft design for a preliminary assessment of the main indicators of the power plant, its dimensions and thermal loads.

Modeling the effect of temperature deformations of large elements on the dynamics of the orbital motion of a small spacecraft

Modeling and Thermal Analysis of a Moving Spacecraft Subject to Solar Radiation Effect

Research of influence of temperature deformations of the big elastic elements on dynamics of a space vehicle

Modeling the temperature shock impact on the movement of a small technological spacecraft

Investigation of the dynamics of a small spacecraft elastic element temperature change under a temperature shock considering a penumbral section

Consideration of the Initial Deformation From Natural Oscillations of Large Elastic Elements of the Spacecraft When Assessing Microaccelerations From Thermal Shock Using a Two-dimensional Model of Thermal Conductivity

Thermal-structural coupled tube element of multibody dynamics and its aplication

Thermal alternation induced vibration analysis of spacecraft with lateral solar arrays in orbit

Dynamic Modeling and Motion Precision Analysis of Spacecraft Manipulator with Harmonic Drive Considering the Alternate Thermal Field in Orbit

Numerical Algorithm For Thermally-Induced Attitude Dynamics Of A Spacecraft With Flexible Appendage

Thermo-Mechanical Jitter in Slender Space Structures: A Simplified Modeling Approach

Research on Active Control for Thermal Deformation of Precise Membrane Reflector With Boundary SMA Actuators

Coupled Thermal-Dynamic Stability Analysis of Large-Scale Space Structures by FEM

A Dynamic Thermal-Mechanical Coupling Numerical Model to Solve the Deformation and Thermal Diffusion of Plates

Modeling dynamics of the spacecraft power plant consisting of Stirling engine and external thermal circuit

Vibration reduction of flexible solar array during orbital maneuver

Space Robot Modeling And Control Considering The Effect Of Orbital Mechanics

Thermal Flutter Analysis of a Spacecraft with a Flexible Appendage Based on FEM

Thermal Flutter Analysis Of Large-Scale Space Structures Based On Finite Element Method

Thermodynamic Analysis of a Space Station Remote Manipulator with a Harmonic Drive That Considers an Integrated Thermal Protection Layer

Dynamic modeling and trajectory optimization for the rigid-flexible coupled spacecraft with the free-floating manipulator and solar panels