Abstract:Currently, it is state of the art to use precipitation hardening 6000-series aluminum alloys to manufacture high-strength aluminum automotive parts by extrusion or in a cold forming process. Alternatively, it is also possible to produce such parts by the use of non-precipitation hardening 5000-series aluminum alloys in a work-hardened condition. Therefore, BENTELER Automobiltechnik GmbH developed a special sheet forming process, henceforth referred to as "flash forming process". The application of the flash forming process, consisting of a rapid heat treatment and a subsequent cold die stamping, increases the forming capability of the work-hardened 5000-series aluminum sheets and results in high-strength parts with a very good ductility and weldability. In addition, this thermal assisted forming process allows a cost-saving production of such high-strength aluminum parts due to lower material costs of 5000-series aluminum alloys than those of a 6000-series material. Furthermore, the weight-saving effects of "flash formed" parts can be higher compared to extruded or cold formed 6000-series aluminum alloys. The suitability of the process is evaluated by forming a commercial AW-5182 H18 aluminum sheet to a crash-relevant automotive part. However, to accurately simulate the flash forming process itself, a temperature dependent fracture model is necessary. Investigations on a coupon basis also showed that the effect of adiabatic heating due to plastic work cannot be neglected. In cooperation with Paderborn University, a detailed mechanical testing, aided by digital image correlation (DIC) and thermal imaging, is carried out to characterize the yield, hardening and fracture behavior at elevated temperatures. The experimental tests are followed by the calibration of a FLD and an incremental stress state dependent fracture model in LS-DYNA. Finally, the simulation models are validated on a cross die deep drawn cup.

Investigation of the forming limit behavior of martensitic chromium steels for hot sheet metal forming

Formability enhancement of EN AW-5182 H18 aluminum alloy sheet metal parts in a flash forming process: testing, calibration and evaluation of fracture models

Microstructural Evolution and Mechanical Properties of 6cr13 Martensitic Stainless Steel Subjected to Cold Rolling and Heat Treatments

Setting Mechanical Properties of High Strength Steels for Rapid Hot Forming Processes

Investigation into the Hot-Forming Limit for 22MnB5 Hot-Forming Steel under a Stamping Process

Effects of soaking temperature on the microstructure and mechanical properties of a medium Mn steel for hot/warm forming

Hot Formability Study of Cr5 Alloy Steel by Integration of FEM and 3D Processing Maps

Experimental and Numerical Determination of Hot Forming Limit Curve of Advanced High-Strength Steel

Development of experimental and theoretical forming limit diagrams for warm forming of austenitic stainless steel 316

Numerical and experimental analysis of the isothermal high temperature pneumoforming process

Effect of Cold and Hot Compounds Forming on Microstructures and Mechanical Properties in the Deformation Zone of Sharp-Edged High-Strength Steel Sections

Formability prediction of high‐strength steel sheet using experimental, analytical and theoretical analysis based on strain and stress forming limit curves and its application to automotive forming parts

Microstructure and high-temperature tensile behavior of spray-formed modified 2000MPa H13 hot work die steel with 0.5wt % carbon

Forming limit of hot-rolled high-strength steels considering sheet thickness effect

Influence of Alloying Elements on the Dynamic Recrystallization of 4 wt.-% Medium Manganese Steels

Ferritic Stainless Steels for High-Temperature Applications: Stabilization of the Microstructure by Solid State Precipitation of MX Carbonitrides

An Experimental Study on the Frictional Behavior of Ultrathin Metal Sheets at Elevated Temperatures

Study of Transition Areas in Press-Hardened Steels in a Combined Tool for Hot and Cold Forming

Effect of hot/warm rolling on the microstructures and mechanical properties of medium-Mn steels

Effect of thermal exposure on structure and properties of die steel 70Kh3G2FTR(m)

3D free thermal bending of BR1500HS high-strength steel tube: Simulation and experimental investigation