Abstract:High-energy chemistry is a method of accelerating chemical reactions by transferring copious amounts of energy to individual molecules. The synthesis of acetylene and benzene is a valuable chemical process used in many organic products. The article proposes an original scheme of experimental setup and technology for plasma-activated methane conversion into acetylene and benzene. The system enables the creation of two distinct active zones within the reactor: the "hot zone," where plasma and active elements are generated, and the "relaxation zone," where the synthesis of organic products occurs. The optimal temperature of the blowing gas, i.e., the gas that propels the plasma reactor walls, has been found to be a crucial factor in heat removal from reaction zones. This temperature has been observed to vary within an interval of 290–310°K, while the reactor gas pressure has been identified as a significant variable within a range of 10–40 mbar. These two factors have been identified as the primary determinants of the yield of products, with acetylene yields reaching approximately 70–80% and maximal benzene yields reaching 40%. Furthermore, the duration of plasma exposure is a critical variable in methane conversion. The optimal acetylene yield of 80% was achieved when the reactor was operated in stationary mode for 15 s. A variation of the input gas flow in flow mode within an interval of 5–15 m 3 /h resulted in a decrease in the yield of acetylene to 60 percent, while an increase in the benzene yield up to 50 percent was observed. This was accompanied by an overall increase in the total volume of products produced per time unit. A general qualitative model of methane reforming is proposed, combining methane dehydration in the plasma flame with direct synthesis of acetylene from carbon and hydrogen atoms in the relaxation zone. Benzene formation occurs through the trimerization of acetylene molecules under heat dissipation near the reactor walls.

Interaction of methane with thermal carbon dioxide plasma obtained in the AC plasma torch

Progress on Reforming of Carbon Dioxide and Methane to Synthesis Gas by Thermal Plasma

Methane Incorporation into Liquid Fuel by Non-Equilibrium Plasma Discharges

Carbon Dioxide Reforming of Methane to Syngas by Thermal Plasma

Experimental Comparison of Methane Pyrolysis in Thermal Plasma

Development and Process of Pyrolysis of Light Alkanes to Acetylene by Thermal Plasma

Reforming of Methane and Carbon Dioxide by DC Water Plasma at Atmospheric Pressure

Synthesis of Acetylene and Benzene in Controlled Methane-Plasma System

CO2 Methane Conversion

Plasma-induced methane catalytic cracking: Effects of experimental conditions

Plasma Activation of Methane for Hydrogen Production in a N2 Rotating Gliding Arc Warm Plasma: A Chemical Kinetics Study

Progress in thermal plasma reactor used for coal pyrolysis to acetylene

Carbon Dioxide and Methane Reforming Using DC Arc Plasma Reactor

Feasibility of a Plasma Furnace for Methane Pyrolysis: Hydrogen and Carbon Production

Chemical Insights into Plasma-Assisted Dry Reforming of Methane in a Nanosecond Discharge

Dry Reforming of Methane with Carbon Dioxide Using Pulsed Dc Arc Plasma at Atmospheric Pressure

Experimental Investigation of Premixed Methane–Air Combustion Assisted by Alternating-Current Rotating Gliding Arc

Experimental study on luminescence and thermal radiation characteristics of plasma assisted-biogas flames changing CO 2 dilution level

Current status and challenges of plasma and plasma-catalysis for methane coupling: A review

Reforming of CH4 and CO2 by Combination of Alternating Current-Driven Nonthermal Arc Plasma and Catalyst

Direct Oxidation of Methane to Methanol over Cu-Based Catalyst in an AC Dielectric Barrier Discharge