Abstract:A series of donor-acceptor oligomer OBTThn (n=1-7) and polymer PBTTh1 and PBTTh2 composed of alternative 2,1,3-benzothiadiazole and 3-hexylthiophene have been designed and synthesized for the purpose of investigation on the effect of chain length and side-chain regioregularity on their basic properties and photovoltaic performance. In the OBTThn oligomers and PBTTh1 polymer, all the hexyl side chains on thienyl units orient toward the same direction. Upon elongation of the chain length, the intramolecular charge transfer (ICT) absorption band in solution gradually redshifts from 398 nm for OBTTh1 to 505 nm for OBTTh7, then to 512 nm for PBTTh1 polymer. Meanwhile, the HOMO energy level increases from -5.45 eV (OBTTh1) to -5.08 eV (OBTTh7) and -5.09 eV (PBTTh1), and the LUMO energy level decreases from -3.11 eV (OBTTh1) to -3.30 eV (OBTTh7) and -3.33 eV (PBTTh1), thus giving a smaller and smaller energy bandgap for higher oligomers and polymers. Theoretical calculation suggests straight line-like backbone geometry for this series of oligomers and polymer. On the other hand, polymer PBTTh2 possesses a different side-chain regioregularity, in which every two neighbor hexyl side chains are arranged in different orienting direction. It is theoretically suggested to have curved line-like backbone geometry. In solution, it shows similar photophysical and electrochemical properties as PBTTh1. However in film state, it displays a less redshift in the ICT band as refer to that in solution than PBTTh1. In combination with [6,6]-phenyl-C-61-butyric acid methyl ester (PC61BM), these oligomers and polymers were used as donor material to fabricate organic bulk heterojunction solar cells. Again, chain length-dependent device photovoltaic performance was observed. The device based on OBTTh4 showed a power conversion efficiency of 0.16%, while it increased to 0.36% and 0.49% for the devices based on OBTTh6 and PBTTh1, respectively. However, the side-chain regioregularity has less influence on the device photovoltaic output since the device based on PBTTh2 displayed an efficiency of 0.52%, comparable to that of PBTTh1.

A structural study of p-type A–D–A oligothiophenes: effects of regioregular alkyl sidechains on annealing processes and photovoltaic performances

Searching Proper Oligothiophene Segment As Centre Donor Moiety for Isoindigo-Based Small Molecular Photovoltaic Materials

Influence of thermal annealing on microstructure, energetic landscape and device performance of P3HT: PCBM-based organic solar cells

In Situ X-ray Scattering Studies of the Influence of an Additive on the Formation of a Low-Bandgap Bulk Heterojunction

Aromatic side chain manipulation in A–DA′D–A type acceptors for organic photovoltaics

Branched Alkyl-chain Engineering of Chlorinated Asymmetrical Acceptors for Improved Organic Photovoltaic Performance

The effect of alkyl substitution position of thienyl outer side chains on photovoltaic performance of A–DA′D–A type acceptors

Direct (hetero)arylation polymerization, electrochemical and optical properties of regioregular 3-substituted polythiophenes with alkylsulphanyl and alkylsulfonyl groups

Effect of different side chains on alternating copolymers of benzodithiophene and thiophene in organic solar cells

Structure evolution from D-A-D type small molecule toward D-A-D-A-D type oligomer for high-efficiency photovoltaic donor materials

Purification and partial amino acid sequence analysis of two distinct tumor necrosis factor receptors from HL60 cells.

Structure Property Relationships: Asymmetric Oligofluorene−Thiophene Molecules for Organic TFTs

Effect of substituting non-polar chains with polar chains on the structural dynamics of small organic molecule and polymer semiconductors

Morphology dependent optical anisotropies in the n-type polymer P(NDI2OD-T2)

Donor-acceptor oligomers and polymers composed of benzothiadiazole and 3-hexylthiophene: Effect of chain length and regioregularity

A–D–A–D–A-Type Oligomer versus A–D–A-Type Small Molecule: Synthesis and Advanced Effect of the D–A Repeat Unit on Morphology and Photovoltaic Properties

Effect of Alkyl Side Chains in BDT and 2D‐BDT Small‐Molecules as Donor Materials for Vacuum‐Processed Organic Photovoltaic Devices

Theoretical study on energy levels and photophysical properties of p-n block oligomers

Joint Electrical, Photophysical and Computational Studies on D-Pi-A Dye Sensitized Solar Cells: the Impacts of Dithiophene Rigidification

Influence Of Alkyl Chains On Photovoltaic Properties Of 3d Rylene Propeller Electron Acceptors

Central core substitution optimized molecular aggregation and photovoltaic performance in A-DA′D-A type acceptors