Abstract:In reality, the remaining oil in the ultra-high water cut period is highly dispersed, so a thorough investigation is required to understand the microscopic remaining oil. This will directly influence the technological direction and allow for countermeasures such as enhanced oil recovery (EOR). Therefore, this study aims to investigate the state, classification method and utilization mechanism of the microscopic remaining oil in the late period of the ultra-high water cut. To achieve this, the classification of microscopic remaining oil based on mechanical mechanism was developed using displacement CT scan and micro-scale flow simulation methods. Three carefully selected mechanical characterization parameters were used: oil–water connectivity, oil–mass specific surface and oil–water area ratio. These give five types of microscopic remaining oil, which are as follows: A (capillary and viscous oil cluster type), B (capillary and viscous oil drop type), C (viscous oil film type), D (capillary force control throat type), and E (viscous control blind end type). The state of the microscopic remaining oil in classified oil reservoirs was defined after high-expansion water erosion. Based on micro-flow simulation and analysis of different forces during the displacement process, the main microscopic remaining oil recognized is in class-I, class-II and class-III reservoirs. Within the Eastern sandstone oilfields in China, the ultra-high water-cut stage is a good indicator that the class-I oil layer is dominated by capillary and viscous oil drop types distributed in large connected holes. The class-II oil layer has capillary and viscous force-controlled clusters distributed in small and medium pores with high connectivity. In the case of the class-III oil layer, it enjoys the support of capillary force control throats that are mainly distributed in small holes with high connectivity. Integrating mechanisms of different types of micro-remaining oil indicates that, enhancing utilization conditions requires increasing pressure gradient and shear force while reducing capillary resistance. An effective way to improve the remaining oil utilization is to increase the pressure gradient and change the flow direction during the water-drive development process. Hence, this forms a theoretical basis and a guide for the potential exploitation of remaining oil. Likewise, it provides a strategy for optimizing enhanced oil recovery in the ultra-high water-cut stage of mid-high permeability oil reservoirs worldwide.

Research on Residual Petroleum in Complex Ultra-low Permeability Fuyu Oil Layer in the Peripheral Area of Western Daqing City and Effect Analysis of Potential Tapping Countermeasures

Microscopic Distribution and Development Strategy of Residual Oil in Tight Sandstone

Study on EOR method in high water cut stage of low permeability A Oilfield

Remaining Oil Distribution Law and Development Potential Analysis after Polymer Flooding Based on Reservoir Architecture in Daqing Oilfield, China

Research on Control Factors of Remaining Oil Distribution

Assessment of Refracturing Potential of Low Permeability Reservoirs Based on Different Development Approaches

Residual Oil Distribution Pattern in a Fault-Solution Carbonate Reservoir and Countermeasures to Improve Oil Development Effectiveness

Dramatically Enhancing Oil Recovery via High-Efficient Re-Fracturing Horizontal Wells in Ultra-Low Permeability Reservoirs: A Case Study in HQ Oilfield, Ordos Basin, China

Advancing PetroChina's Development Strategies for Low-Permeability Oil Reservoirs

Experimental Study on Microscopic Water Flooding Mechanism of High-Porosity, High-Permeability, Medium-High-Viscosity Oil Reservoir

A Fuzzy Method to Evaluate Remaining Oil Potentiality of PI Group

Research on Effectiveness and Application of Fixed-Plane Perforation Fracturing Technology in Ultra-Low-Permeability Reservoir

Study on distribution characteristics of microscopic residual oil in low permeability reservoirs

Practice and cognition of effective water-flooding development mode in Gaotaizi block of ultra-low permeability reservoir

Density cutting volume fracturing technology for horizontal wells in the ultra-low permeability reservoirs: a case study of the Yuan284 area in the Huaqing oilfield Ordos Basin, China

The Formation Mechanism of Residual Oil and Methods of Enhanced Oil Recovery in a Fractured Low-Permeability Metamorphic Rock Reservoir in Bohai Bay

Feasibility Study of Gas Injection in Low-Permeability Reservoirs of Changqing Oilfield

Microscopic Remaining Oil Classification Method and Utilization Based on Kinetic Mechanism

New Insights into Reservoir Architecture of Fuyu Oil Layer in Southern Songliao Basin Based on Analyses of Water-Flooding Characteristics

Optimization of large-scale fracturing technology and improvement of development effect of hard-to-recover reservoirs

A New Method for Ultra-Low Permeability Reservoir Characterization After Water Flooding Development