Abstract:Combustion system development in power generation is discussed ranging from the pre-environmental era in which the objectives were complete combustion with a minimum of excess air and the capability of scale up to increased boiler unit performances, through the environmental era (1970–), in which reduction of combustion generated pollution was gaining increasing importance, to the present and near future in which a combination of clean combustion and high thermodynamic efficiency is considered to be necessary to satisfy demands for CO2 emissions mitigation.From the 1970s on, attention has increasingly turned towards emission control technologies for the reduction of oxides of nitrogen and sulfur, the so-called acid rain precursors. By a better understanding of the NOx formation and destruction mechanisms in flames, it has become possible to reduce significantly their emissions via combustion process modifications, e.g. by maintaining sequentially fuel-rich and fuel-lean combustion zones in a burner flame or in the combustion chamber, or by injecting a hydrocarbon rich fuel into the NOx bearing combustion products of a primary fuel such as coal.Sulfur capture in the combustion process proved to be more difficult because calcium sulfate, the reaction product of SO2 and additive lime, is unstable at the high temperature of pulverized coal combustion. It is possible to retain sulfur by the application of fluidized combustion in which coal burns at much reduced combustion temperatures. Fluidized bed combustion is, however, primarily intended for the utilization of low grade, low volatile coals in smaller capacity units, which leaves the task of sulfur capture for the majority of coal fired boilers to flue gas desulfurization.During the last decade, several new factors emerged which influenced the development of combustion for power generation. CO2 emission control is gaining increasing acceptance as a result of the international greenhouse gas debate. This is adding the task of raising the thermodynamic efficiency of the power generating cycle to the existing demands for reduced pollutant emission. Reassessments of the long-term availability of natural gas, and the development of low NOx and highly efficient gas turbine–steam combined cycles made this mode of power generation greatly attractive also for base load operation.However, the real prize and challenge of power generation R&D remains to be the development of highly efficient and clean coal-fired systems. The most promising of these include pulverized coal combustion in a supercritical steam boiler, pressurized fluid bed combustion without or with topping combustion, air heater gas turbine-steam combined cycle, and integrated gasification combined cycle. In the longer term, catalytic combustion in gas turbines and coal gasification-fuel cell systems hold out promise for even lower emissions and higher thermodynamic cycle efficiency. The present state of these advanced power-generating cycles together with their potential for application in the near future is discussed, and the key role of combustion science and technology as a guide in their continuing development highlighted.

Formation Mechanisms and Methods for Calculating Pollutant Emissions from Natural Gas Combustion Depending on the Burner Emission Class

Measurements and Modelling of Oxy-Fuel Coal Combustion

COMPUTATIONAL AND EXPERIMENTAL STUDIES OF THE AREA OF SUSTAINABLE COMBUSTION OF NATURAL GAS WITH AIR

Numerical Studies of a Water-cooled Premixed Burner for Low NOx Combustion of Natural Gas

Furnace devices aerodynamics optimization for fuel combustion efficiency improvement and nitrogen oxide emission reduction

Emission of Harmful Substances from the Combustion of Wood Pellets in a Low-Temperature Burner with Air Gradation: Research and Analysis of a Technical Problem

Improving the Fuel Combustion Quality Control System in Medium Power Boilers

Formation of Energy Supply Systems for Special Economic Zones

Numerical Studies of a Water-cooled Premixed Burner for Low NO x Combustion of Natural Gas

Research: influence of air classification ratio on low nitrogen performance of natural gas burner

Justification of methodical approaches to determining the theoretical fuel combustion temperature in a blast furnace when changing the parameters of the melting mode

Calculation of combustion air required for burning solid fuels (coal / biomass / solid waste) and analysis of flue gas composition

CLIMATE AND ENVIRONMENTAL BACKGROUNDS OF FUEL UTILIZATION, INFLUENCING UPON ALTERATION THE EUROPEAN AND UKRAINIAN TRENDS OF GAS SUPPLY. PART 2. PROVIDING THE EFFICIENCY OF FUEL USE IN CONDITIONS OF DECARBONIZATION OF ENVIRONMENT

Combustion technology developments in power generation in response to environmental challenges

Heat Production in Considering Boilers and their Influence on CO and NOx Emission Values

Research on Full Premixed Combustion and Emission Characteristics of Non-Electric Gas Boiler

Influence of the method of air-fuel mixture supply on the main characteristics of heat and mass transfer processes

CALCULATION OF HEAT TRANSFER INTENSITY OF GAS FUEL COMBUSTION PRODUCTS

Formation features of benz(a)pyrene and nitrogen oxides when burning brown coal in boilers with liquid slag removal system

Mechanisms And Applications Of Catalytic Combustion Of Natural Gas

Investigation of NOx emission under different burner structures with the optimized combustion model