Abstract:Link for citation: Mrakin A.N., Afanaseva O.V., Kuleshov O.Yu. Calculation of heat transfer intensity of gas fuel combustion products. Bulletin of the Tomsk Polytechnic University. Geo Аssets Engineering, 2023, vol. 334, no. 5, рр.109-115. The relevance of the research is determined by the modern trend in the field of thermal power engineering and heat engineering for the transition from traditional gaseous fuel (methane) to the use of hydrogen, methane-hydrogen mixtures, as well as thermochemical conversion gases. Switching to new non-design fuel is justified by considerations of reducing the negative impact on the environment and increasing the thermal efficiency of fuel combustion plants. In this case, the use of fuels with a composition different from the design one will affect the heat transfer processes. The main aim: carrying out a comparative analysis of indicators of the intensity of radiant and convective heat transfer of combustion products of non-design fuels, such as hydrogen, methane-hydrogen mixture and thermochemical conversion gases. As an assumption in the formulation of the problem and objectives of the study, the constancy of the heat release power in the apparatus due to changes in the amount of fuel burned was taken. Objects: heat exchange surface of a fire-tube hot water boiler. Methods: carrying out numerical calculation using traditional approaches to determine the indicators of the intensity of heat transfer in the system «combustion products – metal wall of the pipe of thermal power plants». We also used the relations tested earlier by other authors to calculate the thermophysical parameters of gas mixtures. Results. According to the results of the performed comparative calculations, we can conclude that the transition from the use of conventional fuel (natural gas/methane) to its thermochemical conversion gases under the considered conditions has almost no effect on the integral heat transfer performance. To a greater extent, this transition is caused by changes in the intensity of heat transfer for products of combustion of hydrogen and methane-hydrogen mixture, which will affect the operation of thermal power and heat technological installations. At the same time, it is necessary to conduct additional research on the combustion kinetics of thermochemical methane conversion gases, their thermophysical properties, etc., because the hardware design, type of the catalyst used and operating parameters of the process will affect the composition of obtained synthesis gas.

Influence of the method of air-fuel mixture supply on the main characteristics of heat and mass transfer processes

The impact of turbulence and combustion models on flames and emissions in a low swirl burner

Numerical analysis of the effect of swirl angle and fuel equivalence ratio on the methanol combustion characteristics in a swirl burner

Computational investigation of oxy-combustion of pulverized coal and biomass in a swirl burner

COMPUTATIONAL AND EXPERIMENTAL STUDIES OF THE AREA OF SUSTAINABLE COMBUSTION OF NATURAL GAS WITH AIR

Computer Technologies of 3D Modeling by Combustion Processes to Create Effective Methods of Burning Solid Fuel and Reduce Harmful Dust and Gas Emissions into the Atmosphere

Mathematical modeling of combustion in a grate-fired boiler burning straw and effect of operating conditions under air- and oxygen-enriched atmospheres

Furnace devices aerodynamics optimization for fuel combustion efficiency improvement and nitrogen oxide emission reduction

Control of Liquid Hydrocarbon Combustion Parameters in Burners with Superheated Steam Supply

MODERN COMPUTING EXPERIMENTS ON PULVERIZED COAL COMBUSTION PROCESSES IN BOILER FURNACES

NUMERICAL SIMULATION OF HEAT AND MASS TRANSFER PROCESSES DURING THE COMBUSTION OF SOLID FUEL OF DIFFERENT MOISTURE IN COMBUSTION CHAMBERS OF POWER PLANTS

Influence of gas composition and properties on the combustion and heat transfer characteristics of pulverized oxy-coal boiler

Investigation of heat and mass transfer processes in the combustion chambe of industrial power plant boiler. Part 2. Distribution of concentrations of O2, CO, CO2, NO

CFD simulation of the combustion process of the low-emission vortex boiler

CALCULATION OF HEAT TRANSFER INTENSITY OF GAS FUEL COMBUSTION PRODUCTS

Experimental study on the effect of particle size on the exit flow field of a swirl burner

Ignition behavior of a mixture of brown coal and biomass during the movement of fine particles in a hot air flow

Numerical study on processes of oxy-fuel combustion of coal-water slurry in the furnace chamber

Aerodynamic Characteristics of a Stoker Furnace with Staged Combustion: Comparison of Cold Modeling Experiments and Numerical Simulations

Experimental study on cold two-phase flow in swirl burner exit

Influence of secondary air blade angle and oxygen-rich combustion characteristics of an improved Babcock swirl burner