Abstract:Pipelines are widely used in energy power system including thermal power plants and nuclear power plants. In the power system, especially nuclear power plants, as thermal stratification characteristic of nonuniform temperature distribution in the pipe and thermal fatigue such as the low cycle thermal fatigue due to existence of the cycle thermal stress are inevitable, the pipe line system can be destroyed easily and thus affect the normal operation of the power plants. In order to study the pipeline thermal fatigue, the pipeline thermal stress needs to be calculated and therefore the temperature distributions especially the inner wall temperature was needed. The outer wall temperature and working fluid temperature can be obtained with installing measuring tools. The key and difficult point is the estimation of the inner temperature distribution of the pipe. At the same time, in the practical engineering, the pipeline structure with special safety requirements or higher requirements for structural completeness are not allowed to be destroyed by the measuring equipment. Based on the consideration above, this paper presents a method of solving the inverse heat conduction problem, which means the inner temperature distributions can be derived by the outer wall temperature distributions. For the pipe inverse heat conduction problem, this paper applies numerical analysis as the main way. Firstly, the method for transient inverse heat conduction problems applying separation of variables and Duhamel's theorem is established. As the effects of the random error on the measured outer wall temperature are inevitable, the measured data need to be smoothed before used as an input. The Gram orthogonal polynomial method based on the digital filtering theory is applied in this paper to accomplish the smoothing process. The inverse process is accomplished by using MATLAB programming. Then this method is verified in the experiment with high temperature and high pressure. In order to directly validate the accuracy of the inverse analysis, for the test section, not only the transient outer wall temperature and fluid temperature were measured, but also the time dependent middle layer temperature were measured. Then the middle layer temperature obtained from inverse calculation was compared with the measured data from the experiment. The calculated results show that the accuracy of this method is high. The temperature distributions along the radical direction can be obtained quickly and accurate instantaneous heat load for the structural stress analysis and thermal fatiglie analysis can be provided using this method. (CSPE)

Thermal evolution monitoring of a chemical reactor wall based on inverse analysis

Thermal Risk Assessment of the Complex Nitration Process Through Safety Operating Space Analysis and Optimization

Runaway criteria for predicting the thermal behavior of chemical reactors

Parametric sensitivity and thermal runaway critical parameters in non-adiabatic fixed bed reactors

Thermal Runaway Criterion for Chemical Reaction Systems: A Modified Divergence Method

CFD Simulation to Study Batch Reactor Thermal Runaway Behavior Based on Esterification Reaction

Thermal risk in batch reactors: Theoretical framework for runaway and accident

Simultaneous estimation of the temperature and heat rate distributions within the combustion region by a new inverse radiation analysis

Investigation on Thermal Runaway in Batch Reactors by Parametric Sensitivity Analysis

A Low-Order Dynamic Model of Counterflow Heat Exchangers for the Purpose of Monitoring Transient and Steady-State Operating Phases

A Numerical Solution For The Transient Inverse Heat Conduction Problem

Solution to inverse natural convection problem using experimental data

Inversion of the Third Boundary Condition on the Inner Wall of a Two-dimensional Pipe Based on Inverse Heat Conduction Problems

Predicting Thermal Runaway in Styrene Polymerization Reactions: Divergence Criterion with Phase Space Reconstruction

Neural Differential Equations for Inverse Modeling in Model Combustors

A Two Dimensional Approach for Temperature Distribution in Reactor Lower Head During Severe Accident

Analysis of batch reactor thermal runaway scenario based on synthesis reaction of isopropyl propionate

Research progress of thermal runaway critical criteria in chemical exothermic system

Numerical inverse heat transfer analysis for temperature-sensitive-paint measurements in hypersonic tunnels

A Novel Local Temperature Change Detection Approach in a 3D Thermal Field

A two-dimensional inverse heat conduction problem for simultaneous estimation of heat convection coefficient, fluid temperature and wall temperature on the inner wall of a pipeline