Abstract:At the current stage of Ukraine's development, the problems of effective use of fuel and energy resources and environmental safety are among the most important. Housing and communal services are among the largest consumers of energy in the state and, accordingly, sources of environmental pollution. The introduction of "green construction" standards in European countries has proven to be effective in reducing the negative impact of construction and engineering infrastructure on the natural environment. A technical solution to the problem of a source of alternative energy due to the use of the heat of the near-surface layers of the earth's crust is proposed. At the depth of placement of probes-heat exchangers, which are structurally part of heat pump installations, the soil temperature is practically unchanged throughout the year and is positive. Non-freezing glycol solutions are used to increase the operational reliability of the installations. A comprehensive analysis of publications and literature demonstrates the absence of a clear scenario for the necessary steps to determine the main parameters of high-capacity heat pump units (more than 30 kW). State regulatory documents contain requirements only for relatively small systems in terms of performance. However, even for such systems, the specific values of the selected thermal energy are indicated in the form of ranges, the discrepancy of which reaches almost 40% between the minimum and maximum values for a certain type of soil. Thus, the resulting effect of thermal energy production cannot be determined precisely. The proposed calculation methodology does not allow taking into account the mutual influence of heat exchangers among themselves. Also, it is impossible to take into account the influence of groundwater. But taking into account the low annual energy productivity, this approach can be considered acceptable. For more powerful systems, it is suggested to perform individual calculations, without a clear road map. Accurate calculations of high-capacity heat pump systems can be carried out only with the help of computer modeling using the finite element method. Initial information can be obtained by placing a test geothermal probe or a group of probes on the project site, with which a thermal response test (TRT) is conducted.

Efficiency of use of waste heat energy on the example of Chelyabinsk

INCREASING THE EFFICIENCY OF COMBINED PRODUCTION HEAT AND ELECTRICITY

Study on Efficient Heating Method by Solar Coupled Air Source Heat Pump System with Phase Change Heat Storage in Severe Cold Region

Waste heat usage

Using biomass to increase the efficiency of heat pump installations.

ANALYSIS OF METHODS OF FORECASTING THE PRODUCTIVITY OF GEOTHERMAL HEAT EXCHANGERS FOR ESTABLISHING HEAT PUMP INSTALLATIONS

Determining the efficiency of local heat recycling wastewater based on a heat exchanger

Application of Concept of Heat Adaptor: Determining an Ideal Central Heating System Using Industrial Waste Heat

System approach to evaluation of the building heating efficiency using geothermal heat pump in the climatic conditions of Western Ural

Evaluation and optimization of water source heat pump for district heating: A case study in steel plant

Methodological aspects of optimization of energy consump-tion costs of low-rise buildings with a built-in air heat pump

Optimization of Heat Source Side Technical Scheme of Combined Heat and Water System Based on a Coal-Fired Power Plant

Geothermal heat pump systems in cold regions: efficiency improvement by use of ambient air

Application of customized absorption heat pumps for utilization of low-grade heat sources

Optimal Schemes And Benefits Of Recovering Waste Heat From Data Center For District Heating By Co2 Transcritical Heat Pumps

Utilization Of Industrial Waste Heat For District Heating A Case Study

The “Smart Home” Heat Supply System Based on District Heating with the Utilization of Secondary Energy Resources Using a heat Pump

Optimising design and operation of sewage source heat pump: techno-economic and environmental assessment

Performance analysis of an efficient waste heat utilization system in an ultra-supercritical coal-fired power plant

Application and Analysis of a Heat Pump System for Building Heating and Cooling Using Extracting Heat Energy from Untreated Sewage

Advanced Exergy and Exergoeconomic Analysis of Cascade High-Temperature Heat Pump System for Recovery of Low-Temperature Waste Heat