Abstract:The residual air saturation plays a crucial role in modeling hydrological processes of groundwater and the migration and distribution of contaminants in subsurface environments. However, the influence of factors such as media properties, displacement history, and hydrodynamic conditions on the residual air saturation is not consistent across different displacement scenarios. We conducted consecutive drainage-imbibition cycles in sand-packed columns under hydraulic conditions resembling natural subsurface environments, to investigate the impact of wetting flow rate, initial fluid state, and number of imbibition rounds (NIR) on residual air saturation. The results indicate that residual air saturation changes throughout the imbibition process, with variations separated into three distinct stages, namely, unstable residual air saturation (S gr-u ), momentary residual air saturation (S gr-m ), and stable residual air saturation (S gr ). The results also suggest that the transition from S gr-u to S gr is driven by changes in hydraulic pressure and gradient; the calculated values followed the following trend: S gr > S gr-u > S gr-m . An increase in capillary number, which ranged from 1.46 × 10 −7 to 3.07 × 10 −6 , increased S gr-u and S gr-m in some columns. The increase in S gr ranged from 0.034 to 0.117 across all the experimental columns; this consistent increase can be explained by water film expansion at the primary wetting front along with a strengthening of the hydraulic gradient during water injection. Both the pre-covered water film on the sand grain surface and a pore-to-throat aspect ratio of up to 4.42 were identified as important factors for the increased residual air saturation observed during the imbibition process. Initial air saturation (S ai ) positively influenced all three types of residual air saturation, while initial capillary pressure (P ci ) exhibited a more pronounced inhibitory effect on residual air saturation, as it can partly characterized the initial connectivity of the air phase generated under different drying flow rates. Under identical wetting flow rate conditions, S gr was higher during the second imbibition than during the first imbibition due to variations in initial fluid state, involving both fluid distribution and the concentration of dissolved air in the pore water. In contrast, NIR did not have an obvious effect on the three types of residual air saturation. This work aims to provide empirical evidences and offer further insights into the capture of non-wetting phases in groundwater environments, as well as to put forward some potential suggestion for future investigations on the retention and migration of contaminants that involves multiphase interface interactions in subsurface environments.

Exploring the impact of long-term evaporation on the relationship between capillary pressure and water saturation in unsaturated porous media

Evaporation and capillary coupling across vertical textural contrasts in porous media

Capillary, Film, and Vapor Flow in Transient Bare Soil Evaporation (2): Experimental Identification of Hydraulic Conductivity in the Medium to Dry Moisture Range

Liquid-phase continuity and solute concentration dynamics during evaporation from porous media: pore-scale processes near vaporization surface

Response of saturation-capillary pressure relationship to the water table fluctuation in a sandy medium

Evaporation-Induced Capillary Siphoning Through Hydraulically Connected Porous Domains: The Vedernikov–Bouwer Model Revisited

Hysteresis of Saturation-Capillary Pressure Relations under Consecutive Drainage-Imbibition Cycles in Fine Sandy Medium

Characteristics of evaporation from partially wettable porous media

Capillary pressure–saturation curves of thin hydrophilic fibrous layers: effects of overburden pressure, number of layers, and multiple imbibition–drainage cycles

Drying in nanoporous media with Kelvin effect: Capillary imbibition against evaporation by smoothed particle hydrodynamics method

Diffusion Hysteresis in Unsaturated Porous Media: A Microfluidic Study

Pore-scale study on the effect of heterogeneity on evaporation in porous media

Factors influencing residual air saturation during consecutive imbibition processes in an air-water two-phase fine sandy medium – A laboratory-scale experimental study

Drying of porous media by concurrent drainage and evaporation: A pore network modeling study

On the Residual Air Saturation of a Fine Sandy Medium under Consecutive Drying-wetting Cycles

Laboratory Experiments and Simulations on the Significance of Non-Equilibrium Effect in the Capillary Pressure-Saturation Relationship

HYSTERESIS OF SATURATION-CAPILLARY PRESSURE RELATIONSHIP UNDER FLUCTUATING WATER LEVEL IN SANDY MEDIUM

Characteristic lengths affecting evaporative drying of porous media

Experimental investigation of water distribution in two-phase zone during gravity-dominated evaporation

Capillary pressure-saturation relations in porous media including the effect of wettability

Understanding the Role of Water Phase Continuity on the Relationship Between Drainage Rate and Apparent Residual Saturation: A Dynamic Network Model Study