Abstract:The evaporation process in porous media typically experiences three main periods, among which the first period, named the constant rate period (CRP), performs most efficiently in removing liquid. We aim to prolong the CRP to very low degrees of saturation (S) and increase its evaporation rate by playing with heterogeneity in wettability and pore size. First, we show that a porous medium with a smaller contact angle at the surface and increasing contact angle towards the inside generally dries out faster compared with that with uniform contact angle. Second, a constant contact angle porous medium with smaller/larger pores in the surface/inside part dries out faster than a medium with uniform pore size. The underlying mechanism is the occurrence of a capillary pressure jump at the border between the two layers accompanied by enhanced capillary pumping, increasing/maintaining the interfacial area in the surface pores. Harnessing the potential of this mechanism, we propose an optimized strategy by combining two heterogeneity effects: increasing contact angle and pore size towards the inside. This strategy is found to be robust both for multilayer and larger systems. In this case, a small drying front first penetrates fast towards the inside and then expands, followed by a horizontal drying front moving back layer by layer to the surface. Quantitatively, compared with evaporation from a homogeneously porous medium with uniform contact angle where CRP stops at , our optimized design can extend the CRP down to , and decrease five-fold the drying time needed to reach .
What problem does this paper attempt to address?
The problem that this paper attempts to solve is: by studying the influence of heterogeneity in porous media (such as the non - uniformity of wettability and pore - size distribution) on the evaporation process, optimize the structure of porous media to prolong the Constant Rate Period (CRP), and increase the evaporation rate under low - saturation conditions. Specifically, the authors hope to find a method that enables porous media to maintain high - efficiency liquid - removal efficiency even at very low saturation levels.
### Research Background and Problem
The evaporation process in porous media usually goes through three main stages:
1. **Constant Rate Period (CRP)**: During this period, the evaporation rate remains basically constant or decreases slightly, mainly affected by external conditions.
2. **Falling Rate Period (FRP)**: During this period, the evaporation rate drops rapidly, with the combined effect of internal and external conditions.
3. **Receding Front Period (RFP)**: During this period, the evaporation rate is limited by the transport characteristics of porous media.
Among them, CRP is the most effective liquid - removal stage. Therefore, prolonging CRP and increasing its evaporation rate can significantly improve the overall drying efficiency. However, in traditional uniform porous media, CRP usually ends at a relatively high saturation (such as \(S = 0.64\)), which limits the further improvement of drying efficiency.
### Solution
To overcome this problem, the authors propose an optimization strategy to improve the evaporation performance by introducing heterogeneity inside the porous media. Specific measures include:
- **Wettability Gradient**: Design porous media with a smaller surface contact angle and a gradually increasing internal contact angle.
- **Pore - Size Gradient**: Design porous media with a smaller surface pore size and a larger internal pore size.
These designs utilize the capillary pressure jump effect, enhance the capillary pumping action, thereby increasing the interfacial area in the surface pores and improving the evaporation efficiency.
### Experimental Results
Through the above - mentioned optimization design, the authors find that:
- The new porous media can maintain CRP at an extremely low saturation (such as \(S = 0.12\)).
- Compared with traditional uniform porous media, the new design can shorten the drying time by five times to reach a drying level of \(S = 0.05\).
In summary, this paper aims to significantly improve the drying efficiency in the evaporation process, especially under low - saturation conditions, by introducing heterogeneity inside the porous media.