Abstract:Lithium-ion batteries undergo structural deformation during operation because of the electrochemical-induced strain caused by the insertion of lithium ions inside the active material of the electrodes. In this work, the mechanical characteristic, i.e. thickness change, of batteries with different chemistries (lithium iron phosphate and lithium cobalt oxide) and formats (prismatic and pouch) is measured in-operando and with different current rates. A dedicated test bench is built to carry out the measurements with contactless triangulation optical sensors, sensing the displacement of the battery surfaces. The results are critically discussed, justifying the trajectory of the thickness change observed experimentally with the mechanical properties of the electrode's active materials. Furthermore, the results obtained with the batteries of different chemistries are compared, discussing the reasons underlying these differences. Statistical considerations on the results, such as repeatability errors and cell-to-cell differences, are provided as well. The mechanical characteristic appears as a three-stage linear curve, with two deflection points between the linear sections, and proportional to the state of charge of the battery. In fact, the mechanical characteristic tells the amount of lithium ions stored in each electrode, which together with the stoichiometric range defining the electrodes balancing, is closely related to the state of charge. Then, these measurements reveal an interesting tool for evaluating the state of charge. The two deflection points of the mechanical characteristic are linked to graphite stage changes. Then, these measurements carry the same information about battery degradation as the peaks in differential voltage analysis. The advantage is that the deflection points remain visible at any current rate, but the peaks in the differential voltage analysis vanish at high current rates. Then, these preliminary studies of the mechanical characteristic evidence it can become a promising alternative tool for evaluating the state of health as well.

High-Precision Monitoring of Volume Change of Commercial Lithium-Ion Batteries by Using Strain Gauges

In operando measuring circumferential internal strain of 18650 Li-ion batteries by thin film strain gauge sensors

Dynamic Volumography of Cylindrical Li-Ion Battery Cells by Watching Its Breath During Cycling

Degradation Diagnosis of Lithium-Ion Batteries Considering Internal Gas Evolution

Mechanical characterization of lithium-ion batteries with different chemistries and formats

Towards Long-Term Monitoring of Commercial Lithium-Ion Batteries Enabled by Externally Affixed Fiber Sensors and Strain-Based Prognostic Strategies

Methods for Quantifying Expansion in Lithium-Ion Battery Cells Resulting from Cycling: A Review

Non-destructive Local Degradation Detection in Large Format Lithium-Ion Battery Cells Using Reversible Strain Heterogeneity

A Practical Approach to Predict Volume Deformation of Lithium‐ion Batteries from Crystal Structure Changes of Electrode Materials

In-situ obtained internal strain and pressure of the cylindrical Li-ion battery cell with silicon-graphite negative electrodes

Reversible and Irreversible Expansion of Lithium-ion Batteries Under a Wide Range of Stress Factors

Volume Deformation Of Large-Format Lithium Ion Batteries Under Different Degradation Paths

Axially and radially inhomogeneous swelling in commercial 18650 Li-ion battery cells

Characterization of Temperature and Strain Changes in Lithium-Ion Batteries Based on a Hinged Differential Lever Sensitization Fiber Bragg Grating Strain–Temperature Simultaneous-Measurement Sensor

Investigation of the Deformation Mechanisms of Lithium-Ion Battery Components Using In-Situ Micro Tests

Operando monitoring of strain field distribution in lithium battery anode via ultra-high spatial resolution optical frequency domain reflectometer

Expanded in situ aging indicators for lithium-ion batteries with a blended NMC-LMO electrode cycled at sub-ambient temperature

Laser Scanning Method for High-Resolution Thickness Mapping of Lithium-Ion Pouch Cells

Operando Decoding of Surface Strain in Anode‐Free Lithium Metal Batteries via Optical Fiber Sensor

Monitoring state of charge and volume expansion in lithium-ion batteries: an approach using surface mounted thin-film graphene sensors

Deformation Analysis of Different Lithium Battery Designs Using the DIC Technique