Abstract:A micromixer is one of the most significant components in a microfluidic system. A three-dimensional micromixer was developed with advantages of high efficiency, simple fabrication, easy integration, and ease of mass production. The designed principle is based on the concepts of splitting–recombination and chaotic advection. A numerical model of this micromixer was established to characterize the mixing performance for different parameters. A critical Reynolds number (Re) was obtained from the simulation results. When the Re number is smaller than the critical value, the fluid mixing is mainly dependent on the mechanism of splitting–recombination, therefore, the length of the channel capable of complete mixing (complete mixing length) increases as the Re number increases. When the Re number is larger than the critical value, the fluid mixing is dominated by chaotic advection, and the complete mixing length decreases as the Re number increases. For normal fluids, a complete mixing length of 500 µm can be achieved at a very small Re number of 0.007 and increases to 2400 µm as the Re number increases to the critical value of 4.7. As the Re number keep increasing and passes the critical Re number, the complete mixing length continues to descend to 650 µm at the Re number of 66.7. For hard-to-mix fluids (generally referring to fluids with high viscosity and low diffusion coefficient, which are difficult to mix), even though no evidence of strong chaotic advection is presented in the simulation, the micromixer can still achieve a complete mixing length of 2550 µm. The mixing performance of the micromixer was also verified by experiments. The experimental results showed a consistent trend with the numerical simulation results, which both climb upward when the Re number is around 0.007 (flow rate of 0.03 μm/min) to around 10 (flow rate of 50 μm/min), then descend when the Re number is around 13.3 (flow rate of 60 µm/min).

Numerical Evaluation of Liquid Mixing in a Serpentine Square Convergent-divergent Passive Micromixer

Numerical simulation of fluid mixing reinforcement in micro-mixers with barriers embedded

A Novel Passive Micromixer with Modified Asymmetric Lateral Wall Structures

Numerical Analysis on a Passive Chaotic Micromixer with Helical Microchannel

A New Micromixer with Helical Microchannel and Research on Its Numerical Flow Field

Numerical Simulation of the Scalar Mixing Characteristics in Three-dimensional Microchannels

Numerical study of passive branches micromixer based on split-and-recombination and vortex mixing

Investigations of the mixing efficiency of five novel micromixer designs with backward arrow inlet using the Villermaux Dushman protocol

A Three-Dimensional Micromixer Using Oblique Embedded Ridges

Numerical and experimental investigation of mixing enhancement in the passive planar mixer with bent baffles

Numerical Investigation on a Chaotic Passive Micromixer Based on Square Chambers Connected with Different Channel Shapes for Enhancing the Mixing Process

Numerical investigation of mixing improvement in a novel spiral microchannel with baffles

Experimental and Numerical Study on Flow Resistance and Bubble Transport in a Helical Static Mixer

A cost-effective serpentine micromixer utilizing ellipse curve

Mixing Performance of a Passive Micromixer Based on Split-to-Circulate (STC) Flow Characteristics

Numerical Simulation and Structural Recombination of Microchannel Micromixer for Excellent Mixing Performance

Mixing behavior of the rhombic micromixers over a wide Reynolds number range using Taguchi method and 3D numerical simulations

Numerical analysis of a microfluidic mixer and the effects of different cross-sections and various input angles on its mixing performance

Design and Mixing Analysis of a Passive Micromixer with Circulation Promoters

Numerical study of a novel electroosmotic active micromixer with twin diamond-shaped chambers and sawteeth

Numerical and Experimental Investigation on a "Tai Chi"-Shaped Planar Passive Micromixer