Fabrication and characterization of graphene oxide–polyethersulfone (GO–PES) composite flat sheet and hollow fiber membranes for oil–water separation

Nurul Fatin Diana Junaidi,Nur Hidayati Othman,Munawar Zaman Shahruddin,Nur Hashimah Alias,Fauziah Marpani,Woei Jye Lau,Ahmad Fauzi Ismail

DOI: https://doi.org/10.1002/jctb.6366

IF: 3.709

2020-05-01

Journal of Chemical Technology and Biotechnology

Abstract:BackgroundIn this work, a series of GO‐PES composite flat sheet (FS) and hollow fiber (HF) membranes were fabricated by blending 0.5 and 1.0 wt % of GO into the PES matrix and utilized for oil‐water separation. GO was first prepared and characterized by using FTIR, SEM, XRD and TGA before being used as membrane's filler. ResultsInterestingly, although similar dope composition was used for the fabrication of HF and FS membranes, their morphology and pore size varied significantly owing to the ways of the membranes fabricated. Significant enhancement of hydrophilicity was observed for both composite FS and HF membranes, where the water contact angle value decreases from 74.8° to 42.2° and 71.4° to 49.8°, respectively. The flux of composite membranes increased up to 150% of the bare membranes especially when 1.0 wt% of GO was added. Although higher oil rejection (~99%) was observed for HF membranes that possess smaller pores, the permeation flux was maintained due to the improve flow dynamic. Lower oil rejection (up to 50%) was observed for FS membranes, which might be due to its big pore sizes particularly at the bottom surface. As more oil droplet sitting on membrane surface and preventing water molecules to pass through membrane, fouling might occur rapidly. ConclusionsThe results obtained in this work suggest that surface hydrophilicity, pore size of membranes and oil‐water separation performances was greatly affected by membrane shape. Owing to many advantages of HF membranes, this type of membrane has great potential for commercial applications.This article is protected by copyright. All rights reserved.

engineering, chemical,biotechnology & applied microbiology, environmental,chemistry, multidisciplinary