One-Pot Preparation of Alumina-Modified Polysulfone-Graphene Oxide Nanocomposite Membrane for Separation of Emulsion-Oil from Wastewater

Vuong Hoan T. Nguyen,Minh N. Nguyen,Tam T. Truong,Tien Trung Nguyen,Huan V. Doan,Xuan Nui Pham
DOI: https://doi.org/10.1155/2020/9087595
IF: 3.791
2020-04-24
Journal of Nanomaterials
Abstract:In recent years, polysulfone-based nanocomposite membranes have been widely used for contaminated water treatment because they comprise properties such as high thermal stability and chemical resistance. In this study, a polysulfone (PSf) nanocomposite membrane was fabricated using the wet-phase inversion method with the fusion of graphene oxide (GO) and alumina (Al 2 O 3 ) nanoparticles. We also showed that GO-Al 2 O 3 nanoparticles were synthesised successfully by using a one-pot hydrothermal method. The nanocomposite membranes were characterised by Fourier transform infrared (FT-IR), scanning electron microscopy (SEM), nitrogen adsorption-desorption isotherms, energy-dispersive X-ray spectroscopy (EDX), thermogravimetric analysis (TGA), and water contact angle. The loading of GO and Al 2 O 3 was investigated to improve the hydrophilic and oil rejection of the matrix membrane. It was shown that by using 1.5 wt.% GO-Al 2 O 3 loaded in polysulfone, ~74% volume of oil was separated from the oil/water emulsion at 0.87 bar and 30 min. This figure was higher than that of the process using the unmodified membrane (PSf/GO) at the same conditions, in which only ~60% volume of oil was separated. The pH, oil/water emulsion concentration, separation time, and irreversible fouling coefficient ( F R w ) were also investigated. The obtained results suggested that the GO-Al 2 O 3 nanoparticles loaded in the polysulfone membrane might have potential use in oily wastewater treatment applications.
materials science, multidisciplinary,nanoscience & nanotechnology
What problem does this paper attempt to address?