Perspectives in Wireless Radio Frequency Coil Development for Magnetic Resonance Imaging

Lena Nohava,Jean-Christophe Ginefri,Georges Willoquet,Elmar Laistler,Roberta Frass-Kriegl
DOI: https://doi.org/10.3389/fphy.2020.00011
IF: 3.718
2020-02-21
Frontiers in Physics
Abstract:This paper addresses the scientific and technological challenges related to the development of wireless radio frequency (RF) coils for magnetic resonance imaging (MRI) based on published literature together with the authors' interpretation and further considerations. Key requirements and possible strategies for the wireless implementation of three important subsystems, namely the MR receive signal chain, control signaling, and on-coil power supply, are presented and discussed. For RF signals of modern MRI setups (e.g., 3 T, 64 RF receive channels), with on-coil digitization and advanced methods for dynamic range (DR ≥ 16-bit) and data rate compression, still data rates &gt; 500 Mbps will be required. For wireless high-speed MR data transmission, 60 GHz WiGig and optical wireless communication appear to be suitable strategies; however, on-coil functionality during MRI scans remains to be verified. Besides RF signals, control signals for on-coil components, e.g., active detuning, synchronization to the MR system, and B<sub>0</sub> shimming, have to be managed. Wireless power supply becomes an important issue, especially with a large amount of additional on-coil components. Wireless power transfer systems (&gt;10 W) seem to be an attractive solution compared to bulky MR-compatible batteries and energy harvesting with low power output. In our opinion, completely wireless RF coils will ultimately become feasible in the future by combining efficient available strategies from recent scientific advances and novel research. Besides ongoing improvement of all three subsystems, innovations are specifically required regarding wireless technologies, MR compatibility, and wireless power supply.
physics, multidisciplinary
What problem does this paper attempt to address?
The problem that this paper attempts to solve is the scientific and technological challenges in developing radio - frequency (RF) coils for magnetic resonance imaging (MRI). Specifically, the paper focuses on how to achieve a fully wireless MR receiving array, which involves significant changes in three main subsystems: the MR receiving signal chain, the control signal, and the power supply on the coil. These changes aim to overcome several key problems existing in the existing wired systems: 1. **Patient safety**: The existing wired systems may cause local heating, which poses a safety hazard to patients. Wireless technology can reduce or eliminate this risk. 2. **Signal interference**: The use of multiple cables can lead to cross - interference between signals, reducing the sensitivity of RF detection. Wireless transmission can reduce this interference. 3. **System complexity**: With the use of high - density and mechanically flexible receiving arrays in modern high - field - strength scanners, the complexity of cables increases, resulting in difficulties in installation and maintenance. Wireless technology can simplify the system structure and improve operational efficiency. 4. **Coil weight and comfort**: Traditional wired coils are usually heavy and inconvenient for patients to use due to the need for a large number of cable connections. Wireless coils can be designed to be lighter and may even be made "wearable", thereby improving patient comfort. To achieve these goals, the paper explores the following technical and strategic aspects: - **MR receiving signal chain**: It discusses the technical requirements and challenges of key steps such as signal amplification, digitization, data compression, and filtering, especially the need for high - dynamic - range (DR) and high - rate data transmission. - **Control signal**: It analyzes the necessity of wireless control signals, including the implementation methods of control functions such as active detuning, synchronization, and B0 shimming. - **Coil power supply**: It explores the application potential of wireless power transfer (WPT) and energy - harvesting technologies in MRI, especially in providing sufficient power to support the operation of electronic devices on the coil. In conclusion, by synthesizing existing literature and technological progress, this paper proposes the possibility of achieving a fully wireless RF coil and points out the directions for future research, including the innovation needs in wireless communication technology, MR compatibility, and wireless power supply.