Abstract:Because of propeller hydrodynamic influence, the shafting vibration is a coupled vibration which includes torsional, longitudinal and whirling vibrations. It is unsuitable to analyze different vibrations of propulsive shafting systems with development of shipbuilding technologies. To overcome the shortages of traditional marine standards, we establish a new numerical model of the shafting coupled vibration. And we put forward shafting coupled vibration calculation to ensure better reliability of main propulsion system. The shafting system is modeled into two sub-systems, a continuous one and a discrete one. Wave approach and transit matrix method are used to investigate displacement and stress fields in continuous and discrete sub-systems, respectively. And vibrations of different modes in both sub-systems are coupled by using dynamic equilibrium and continuity condition to deduce the global equations governing the motion of shafting. The coupling calculation is then used to research the reason of a very large crude carrier (VLCC) stern hull vibration. It is shown by the comparison of the results from both coupling and dependent vibration calculations that vibration in deferent directions will cause deformation in the same mode, which leads to extra stress and displacements on shafting, especially as the resonant frequencies of different vibration modes match each other. This is helpful to prevent ship stern vibration due to poor shafting vibration calculation.

Analysis of Hydraulic Damping Shock Absorber of Ship Propulsion Shaft System

Design and Analysis of a Dynamic Absorber for Reducing Axial Vibration of Ship Shafting

Study on Suppression of the Longitudinal Vibration of Ship’s Propulsion Shafting System

Shock Response Analysis of a Ship Power Shafting System

A multimodal dynamic vibration absorber for controlling longitudinal vibration of propulsion shafting system

Experimental and Numerical Study on Vibration of the Full-Revolving Propulsion Ship Stern

Analysis of Vibration Characteristics of Podded Propulsor Shafting Based on Analytical Method

Effects of the Stiffness of Vibration Isolators on Anti-shock Dynamics for Propulsive Shafting of Ship

Study on Torsional Vibration Response Characteristics of Marine Propulsion Shafting

Experimental Investigation on the Noise Reduction of an Axial Piston Pump Using Free-Layer Damping Material Treatment

Experiment Research of Axial Dynamic Vibration Absorbers Based on Magneto-Rheological Elastomers Using for Ship Shafting

Research on longitudinal vibration suppression of underwater vehicle shafting based on particle damping

Torsional-longitudinal shock responses of a ship propulsion shaft system

Longitudinal Vibration of Marine Propulsion Shafting: Experiments and Analysis

Vibration Reduction Performance of Damping-Enhanced Water-Lubricated Bearing Using Fluid-Saturated Perforated Slabs

Minimization of the vibration transmission through the propeller‐shafting system in a submarine

Shafting Coupled Vibration Research Based on Wave Approach

Simulation and experimental investigations on water-lubricated squeeze film damping stern bearing

Modeling and Analysis for Coupled Vibration of a Shaft-Hull System

Theoretical analysis on vibration transmission control in a shaft-hull system excited by propeller forces via an active multi-strut assembly

Study on Characteristics of Propeller Exciting Force Induced by Axial Vibration of Propulsion Shafting: Theoretical Analysis