Abstract:Abstract A new mixed-flow radial turbine design for industrial applications was developed and experimentally investigated. The presented mixed-flow turbine recovers energy in industrial processes, which have unused pressurized, hot off-gas available. The design parameter values are very similar to the ones of mixed-flow turbines for turbocharger applications. Consequently, a turbocharger design was used as starting basis. The mechanical requirements of the industrial application are less challenging for the turbine design. It was possible to extend the design space of the blades far beyond the typical radial fiber constraint, which is usually used to fulfill the mechanical restrictions. This gives more freedom for the parameters used in the blade geometry generation. The final design has an increased efficiency and operating range. In addition to a maximized design point efficiency, a wide operating range is one of the major requirements concerning the turbine performance. During the development process of the radial turbine’s wheel, an automated optimization was used. Due to the competitive design targets, multiple objectives and constrains were formulated. To satisfy the off-design efficiency requirements, each geometry was analyzed by means of six operating points. The mechanical integrity was checked by directly coupled FE simulations. The final design is further investigated and the reasons for the gained improvements are discussed. An experimental investigation of a prototype confirmed the numerically predicted improvements. A comparison of the measurements and the numerical results are shown. The objective of the paper is to show the possible potentials in efficiency and operating range of radial turbines with low mechanical restrictions. In many energy recovery applications, the operating conditions are well known and within clearly defined boundaries. For these applications, it is possible to engineer mixed-flow turbines primarily from the aerodynamical point of view ans secondly from the mechanical one. In the following described work, it was possible, starting from a good turbocharger design, to increase the turbine’s performance. An automatic multi-point and multi-physics optimization was set up to reach the performance improvements.

Numerical and experimental investigations of a turbocharger with a compressor wheel made of additively manufactured plastic

Ceramic and Metal Additive Manufacturing of Monolithic Rotors From Sialon and Inconel and Comparison of Aerodynamic Performance for 300W Scale Microturbines

Investigation on topology-optimized compressor piston by metal additive manufacturing technique: Analytical and numeric computational modeling using finite element analysis in ANSYS

Evaluation of Selected Dynamic Parameters of Rotating Turbocharger Units Based on Comparative Model and Bench Tests

Performance analysis of turbocharger rotor friction pairs of an automobile engine

Towards Sustainability in Hydraulic Machinery Manufacturing by 3D Printing

Experimental and Numerical Verification of an Optimization of a Fast Rotating High-Performance Radial Compressor Impeller

The Design and Optimization of Additively Manufactured Radial Compressor of a Miniature Gas Turbine Engine

Design study for performance improvement of a hybrid pico pelton turbine and its additive manufacturing using a laser powder bed fusion method

Application of additive technologies for manufacturing turbine stator parts in aircraft engines

Wind Tunnel Testing and Validation of Helicopter Rotor Blades Using Additive Manufacturing

Rotor Design, Analysis and Experimental Validation of a High-Speed Permanent Magnet Synchronous Motor for Electric Turbocharger

A Physics-Based Turbocharger Model for Automotive Diesel Engine Control Applications

Numerical and Experimental Investigation of Pulsating Flow Effect on A Nozzled and Nozzleless Mixed Flow Turbine for an Automotive Turbocharger

TEORETICAL-EXPERIMENTAL COMPARISON OF THE MODELS OF ADDITIVELY MANUFACTURED SWIRL INJECTORS BASED ON THE HYDRAULIC TESTING RESULTS

Numerical and experimental investigation of a cooling technique of a turbocharger radial turbine

Combination of Turbocharger and Industrial Technologies for the Development of an Improved Mixed-Flow Turbine Design

Centrifugal Compressor Stall Control by the Application of Engineered Surface Roughness on Diffuser Shroud Using Numerical Simulations

Comparative Life Cycle Assessment of a centrifugal compressor impeller: Hybrid technology production versus welding production

Fabrication of TiAl alloys turbocharger turbine wheel for engines by metal injection molding

Design Optimisation of a Screw Compressor with a Focus on Rotor Depth: A Computational Fluid Dynamics Approach