Electrocatalytic and photoelectrocatalytic investigation of Orange G degradation utilizing a novel BHP@Bi 2 O 3 photoanode employing the CCD-RSM experimental design
Ayoub Ahdour,Aziz Taoufyq,Latifa Aneflous,Bahcine Bakiz,Abdeljalil Benlhachemi
DOI: https://doi.org/10.1016/j.jelechem.2024.118317
IF: 4.598
2024-05-04
Journal of Electroanalytical Chemistry
Abstract:In this study, we synthesized a bilayer film consisting of BaHPO 4 (BHP) and Bi 2 O 3 through the electrodeposition technique. The produced anode was subjected to characterization using cyclic voltammetry to clarify the deposition reactions. Subsequent to this, structural and morphological analyses were conducted utilizing X-ray diffraction alongside scanning electron microscopy, coupled with energy-dispersive X-ray spectroscopy. Additionally, UV–vis diffuse reflectance spectroscopy was employed to determine the bandgap energies of both semiconductors. Following an electrochemical characterization using linear sweep voltammetry (LSV), electrochemical impedance spectroscopy (EIS), and Mott-Schottky (MS) measurements, the photoanode was employed for the electro-degradation of the anionic dye Orange G (OG), varying key degradation parameters such as current density, pollutant concentration, supporting electrolyte concentration, and pH using the CCD-RSM experimental design method. A degradation efficiency of 98% was achieved within a 20-minute timeframe. Photoelectrocatalytic tests under UV irradiation reduced the degradation time from 20 to 6 min, with a degradation rate of 99%. Additionally, under the same conditions, the BHP@Bi 2 O 3 photoanode exhibited good stability, enduring up to 11 cycles of use.
chemistry, analytical,electrochemistry