Abstract:Red fluorescent molecules suffer from large, non-radiative internal conversion rates (k(IC)) governed by the energy gap law. To design efficient red thermally activated delayed fluorescence (TADF) emitters for organic light-emitting diodes (OLEDs), a large fluorescence rate (k(F)) as well as a small energy difference between the lowest singlet and triplet excited states (Delta E-ST) is necessary. Herein, we demonstrated that increasing the distance between donor (D) and acceptor (A) in intramolecular-charge-transfer molecules is a promising strategy for simultaneously achieving small Delta E-ST and large k(F). Four D-Ph-A-Ph-D-type molecules with an anthraquinone acceptor, phenyl (Ph) bridge, and various donors were designed, synthesized, and compared with corresponding D-A-D-type molecules. Yellow to red TADF was observed from all of them. The k(F) and Delta E-ST values determined from the measurements of quantum yield and lifetime of the fluorescence and TADF components are in good agreement with those predicted by corrected time-dependent density functional theory and are approximatively proportional to the square of the cosine of the theoretical twisting angles between each subunit. However, the introduction of a Ph-bridge was found to enhance k(F) without increasing Delta E-ST. Molecular simulation revealed a twisting and stretching motion of the NC bond in the D-A-type molecules, which is thought to lower Delta E-ST and k(F) but raise k(IC), that was experimentally confirmed in both solution and doped film. OLEDs containing D-Ph-A-Ph-D-type molecules with diphenylamine and bis(4-biphenyl)amine donors demonstrated maximum external quantum efficiencies of 12.5% and 9.0% with emission peaks at 624 and 637 nm, respectively.

Saturated Red Electroluminescence From Thermally Activated Delayed Fluorescence Conjugated Polymers

Synthesis and performances of chelating electrophosphorescent polymers based on different ancillary ligands

Anthraquinone-Based Intramolecular Charge-Transfer Compounds: Computational Molecular Design, Thermally Activated Delayed Fluorescence, and Highly Efficient Red Electroluminescence

Red-Emitting Dpsb-Based Conjugated Polymer Nanoparticles with High Two-Photon Brightness for Cell Membrane Imaging

Rigidity and Polymerization Amplified Red Thermally Activated Delayed Fluorescence Polymers for Constructing Red and Single‐Emissive‐Layer White OLEDs

Fluorene-carbazole-based hyperbranched polymers with linear red TADF chromophores for high-efficiency white and red electroluminescent devices

Efficient, saturated red electroluminescent devices with modified pyran-containing emitters

Backbone‐Acceptor/Pendant‐Donor Strategy for Efficient Thermally Activated Delayed Fluorescence Conjugated Polymers with External Quantum Efficiency Close to 25% and Emission Peak at 608 nm

Highly Efficient Orange-Red Thermally Activated Delayed Fluorescence Compounds Comprising Dual Dicyano-Substituted Pyrazine/Quinoxaline Acceptors

Novel Red Light-Emitting Polymers Based on 2,7-Carbazole and Thiophene Derivatives

Solution-processable thermally activated delayed fluorescence red emitters poly(carbazole-fluorene) containing naphthalene imide units

Effect of a Pendant Acceptor on Thermally Activated Delayed Fluorescence Properties of Conjugated Polymers with Backbone-Donor/Pendant-Acceptor Architecture

Creating Efficient Red Thermally Activated Delayed Fluorescence Materials with Cyano-Substituted 11,12-Diphenyldipyrido[3,2-a:2',3'-c]phenazine Acceptors

Monochromatic-Red-Light Emission of Novel Copolymers Containing Carbazole Units and Europium-Acrylate Complexes

A Red-Emitting Cationic Hyperbranched Polymer: Facile Synthesis, Aggregation-Enhanced Emission, Large Stokes Shift, Polarity-Insensitive Fluorescence and Application in Cell Imaging

Dicarbazolyldicyanobenzenes as Thermally Activated Delayed Fluorescence Emitters: Effect of Substitution Position on Photoluminescent and Electroluminescent Properties

Design, synthesis, and electroluminescence of red TADF dyes based on cyanophenanthrene

Towards highly efficient red thermally activated delayed fluorescence materials by the control of intra-molecular π-π stacking interactions.

Deep-red thermally activated delayed fluorescence emitters based on a phenanthroline-containing planar acceptor

Red to orange thermally activated delayed fluorescence polymers based on 2-(4-(diphenylamino)-phenyl)-9 H-thioxanthen-9-one-10,10-dioxide for efficient solution-processed OLEDs

Efficient Red Thermally Activated Delayed Fluorescence Emitters Based on a Dibenzonitrile-Substituted Dipyrido[3,2-a:2′,3′-c]phenazine Acceptor