Abstract:Red fluorescent molecules suffer from large, non-radiative internal conversion rates (k(IC)) governed by the energy gap law. To design efficient red thermally activated delayed fluorescence (TADF) emitters for organic light-emitting diodes (OLEDs), a large fluorescence rate (k(F)) as well as a small energy difference between the lowest singlet and triplet excited states (Delta E-ST) is necessary. Herein, we demonstrated that increasing the distance between donor (D) and acceptor (A) in intramolecular-charge-transfer molecules is a promising strategy for simultaneously achieving small Delta E-ST and large k(F). Four D-Ph-A-Ph-D-type molecules with an anthraquinone acceptor, phenyl (Ph) bridge, and various donors were designed, synthesized, and compared with corresponding D-A-D-type molecules. Yellow to red TADF was observed from all of them. The k(F) and Delta E-ST values determined from the measurements of quantum yield and lifetime of the fluorescence and TADF components are in good agreement with those predicted by corrected time-dependent density functional theory and are approximatively proportional to the square of the cosine of the theoretical twisting angles between each subunit. However, the introduction of a Ph-bridge was found to enhance k(F) without increasing Delta E-ST. Molecular simulation revealed a twisting and stretching motion of the NC bond in the D-A-type molecules, which is thought to lower Delta E-ST and k(F) but raise k(IC), that was experimentally confirmed in both solution and doped film. OLEDs containing D-Ph-A-Ph-D-type molecules with diphenylamine and bis(4-biphenyl)amine donors demonstrated maximum external quantum efficiencies of 12.5% and 9.0% with emission peaks at 624 and 637 nm, respectively.

Dicarbazolyldicyanobenzenes as Thermally Activated Delayed Fluorescence Emitters: Effect of Substitution Position on Photoluminescent and Electroluminescent Properties

Pyrazine-Based Blue Thermally Activated Delayed Fluorescence Materials: Combine Small Singlet–Triplet Splitting with Large Fluorescence Rate

Design of Efficient Thermally Activated Delayed Fluorescence Materials for Pure Blue Organic Light Emitting Diodes.

Highly Efficient Orange-Red Thermally Activated Delayed Fluorescence Compounds Comprising Dual Dicyano-Substituted Pyrazine/Quinoxaline Acceptors

A new dicyanophenanthrene-based thermally activated delayed fluorophore: Design, synthesis, photophysical study, and electroluminescence application

High-Efficiency Deep-Blue Organic Light-Emitting Diodes Based on A Thermally Activated Delayed Fluorescence Emitter

Deep-blue thermally activated delayed fluorescence emitter with a very high fluorescence rate

Dipyrido[3,2-a:2′,3′-c]phenazine acceptor based thermally activated delayed fluorescence emitters

Expanding the Hole Delocalization Range in Excited Molecules for Stable Organic Light-Emitting Diodes Employing Thermally Activated Delayed Fluorescence

Persistent Dimer Emission in Thermally Activated Delayed Fluorescence Materials

Thermally Activated Delayed Fluorescent Materials Combining Intra- and Intermolecular Charge Transfers

Efficient and Stable Organic Light-Emitting Diodes Employing Indolo[2,3-b]indole-Based Thermally Activated Delayed Fluorescence Emitters.

Anthraquinone-Based Intramolecular Charge-Transfer Compounds: Computational Molecular Design, Thermally Activated Delayed Fluorescence, and Highly Efficient Red Electroluminescence

Efficient thermally activated delayed fluorescence carbazole derivatives with a cofacial acceptor/donor/acceptor chromophore: comparable luminescent properties to their counterparts with the opposite configuration of donor/acceptor/donor

A sky-blue thermally activated delayed fluorescence emitter based on multimodified carbazole donor for efficient organic light-emitting diodes

Design of Thermally Activated Delayed Fluorescence Materials: Transition from Carbonyl to Amide‐Based Acceptors

A Series of Fused Carbazole/Carbonyl Based Blue to Yellow‐Green Thermally Activated Delayed Fluorescence Materials for Efficient Organic Light‐Emitting Diodes

Thermally activated delayed fluorescence materials based on 3, 3′-position substituted bis(phenylsulfonyl)benzene

Efficient Red Thermally Activated Delayed Fluorescence Emitters Based on a Dibenzonitrile-Substituted Dipyrido[3,2-a:2′,3′-c]phenazine Acceptor

Isomeric Modulation of Thermally Activated Delayed Fluorescence in Dibenzo[a,c]phenazine-based (Deep) Red Emitters

Design and Synthesis of Pyrazino[2,3-f][1,10]phenanthroline-Based Color-Tunable Thermally Activated Delayed Fluorescence Emitters: Exploring Novel Molecular Architectures for High-Efficiency Organic Light-Emitting Diodes.