Hinge location and apical drill holes in opening wedge high tibial osteotomy: A finite element analysis

Anna Boström,Anish K. Amin,Gavin J. Macpherson,Pankaj Pankaj,Chloe E. H. Scott
DOI: https://doi.org/10.1002/jor.24704
2020-05-07
Journal of Orthopaedic Research
Abstract:<p>At the time of medial opening wedge high tibial osteotomy (HTO) to realign the lower limb and offload medial compartment knee osteoarthritis, unwanted fractures can propagate from the osteotomy apex. The aim of this study was to use finite element (FE) analysis to determine the effect of hinge location and apical drill holes on cortical stresses and strains in HTO.</p><p>A monoplanar medial opening wedge HTO was created above the tibial tuberosity in a composite tibia. Using the FE method, intact lateral hinges of different widths were considered (5, 7.5 and 10mm). Additional apical drill holes (2, 4 and 6mm diameters) were then incorporated into the 10mm hinge model. The primary outcome measure was maximum principal strain in the cortical bone surrounding the hinge axis. Secondary outcomes included the force required for osteotomy opening, minimum principal strain and mean cortical bone stresses (maximum principal/minimum principal/von Mises).</p><p>Larger intact hinges (10mm) were associated with higher cortical bone maximum principal strain and stress, lower minimum principal strain/stress and required greater force to open. Lateral cortex strain concentrations were present in all scenarios, but extended to the joint surface with the 10mm hinge. Apical drill holes reduced the mean cortical bone maximum principal strain adjacent to the hinge axis: 2mm hole 6% reduction; 4mm 35% reduction; 6mm 55% reduction. Incorporating a 4mm apical drill hole centred 10mm from the intact lateral cortex maintains a cortical bone hinge, minimises cortical bone strains and reduces the force required to open the HTO thus improving control.</p><p>This article is protected by copyright. All rights reserved.</p>
orthopedics
What problem does this paper attempt to address?