Abstract:We describe a flow-through ionic charge detector in the form of a three-compartmented system. A central water channel is separated from two outer channels bearing water (or a dilute electrolyte) by a cation-exchange membrane (CEM) and an anion-exchange membrane (AEM). Independent fluid input/output ports address all channels. One platinum electrode is put in each outer channel. When the AEM-side electrode is positive with respect to the CEM-side electrode and voltage (approximately 1-10 V) is applied, the observed background current is from the transport of H(+)/OH(-) through the CEM/AEM to the negative/positive electrodes, respectively. The H(+) and OH(-) are generated by the ionization of water, in part aided by the electric field. If an electrolyte (X(+)Y(-)) is injected in to the central channel, X(+) and Y(-) migrate through the CEM and AEM to the negative and positive electrodes, respectively, and generate a current pulse. The integrated area of the current signal (coulombs) elicited by this electrolyte injection is dependent on a number of variables, the most important being the central channel residence time and the applied voltage (V(app)); these govern the transport of the injected electrolyte to/through the membranes. Other parameters include electrode placement, fluid composition, and outer channel flow rates. For strong electrolytes, depending on the operating conditions, the current peak area (hereinafter called the measured charge signal, Q(m)) can both be less or more than the charge represented by the electrolyte injected (Q(i)). Q(m) is less than Q(i) if transport to/through the membranes is subquantitative. Q(m) can be greater than Q(i) at higher V(app). At constant V(app) more voltage is dropped across the membranes as the central channel becomes more conductive and water dissociation at the membrane surface is enhanced. Effectively, the membranes experience a greater applied voltage as the central channel becomes more conductive. The resulting additional current accompanying analyte introduction to the detector can substantially augment Q(m). Thus, the device is not an absolute coulometer although V(app) can be deliberately chosen to have Q(m) = Q(i) over at least a 10-fold concentration range. Importantly, equivalent amounts of diverse strong electrolytes (with substantially different conductivities) injected into the central channel produce the same charge signals. In ion chromatography, this results in identical calibration curves for all strong acid anions, obviating individual calibrations. Whereas with a conductivity detector (CD) only the ionized portion of a weak electrolyte responds, in the present charge detector (ChD), ions are actually removed, leading to further ionization and the detection of a proportionately greater analyte amount.

Electrophoretic measurement of water charge density and ion hydration

Scanning probe imaging of surface ion conductance in an anion exchange membrane

Energy Characterization of Effect for Ions on the Structure of Water

New Insights into the Dynamics of Zwitterionic Micelles and Their Hydration Waters by Gigahertz-to-Terahertz Dielectric Spectroscopy

Water content of ion-exchange membranes: Measurement technique and influence on the ion mobility

Dynamic permittivity of confined water under a static background field

Charge Detector for the Measurement of Ionic Solutes.

An electrophoretic ion analyzer for on-site autonomous water monitoring

A Molecular Simulation Study on the Role of Ion Sizes and Dielectric Images in Near-Surface Ion Distribution Far from the Strong Coupling Limit

Separating Hofmeister Trends in the Stern and Diffuse Layer Structures at a Charged Aqueous Interface

Quantification of pore induction in human epidermal membrane during iontophoresis: the importance of background electrolyte selection

Dynamic hydration numbers for biologically important ions

In Situ Study of Diffusion and Interaction of Water and Mono- or Divalent Anions in a Positively Charged Membrane Using Two-Dimensional Correlation FT-IR/Attenuated Total Reflection Spectroscopy

Measurement of Electric Modification of Cell Suspension Conductivity During Treatment

Ion Transfer Reactions in Media of Low Ionic Strength

Influence to the Structure and Dynamics of Hydrated Ca2+ and Water Molecules in CaCl2 Aqueous Solution Caused by External AC Electric Field: A Mechanism Study by Molecular Dynamics Simulation

Molecular Dynamics in Physiological Solutions: Force Fields, Alkali Metal Ions, and Ionic Strength

The hydration structure of the Na+ and K+ ions and the selectivity of their ionic channels

Ion and Water Dynamics in the Transition from Dry to Wet Conditions in Salt-Doped PEG

Electrophoretic Properties of Highly Charged Colloids: A Hybrid MD/LB Simulation Study

Effective charges and virial pressure of concentrated macroion solutions