Study on treatment of paper mill wastewater by electrocoagulation and its sludge analysis

Neha Pandey,Chandrakant Thakur

DOI: https://doi.org/10.1016/j.cdc.2020.100390

2020-06-01

Chemical Data Collections

Abstract:Electrocoagulation (EC) process was used for the treatment of recycled fiber based paper mill wastewater. The present study deals with the economical solution of EC process by using perforated electrodes and vary different process parameters like electrode distance (ED), current density (CD), conductivity and pH. Further, study on sludge generated during EC process was also performed. EC process shows maximum reduction of COD 95 %, Color 67% and TDS value of the treated sample was found 1340mg/L. The result was achieved at operating condition pH=7.15, CD= 20 mA/cm2, ED= 2 cm and conductivity= 3.15 mS/cm. The results suggest that 20 min of electrolysis time was enough for maximum reduction of organic load. This is considered as an optimum condition of the process. At this operating condition cell voltage utilization was 1.1 V with energy consumption of 2.3 kWh/kg of anode dissolution and cost of operation to treat 1 liter effluent was found 65 INR (0.83€) approximate. Proximate analysis of sludge shows moisture contents, volatile matter, ash and fixed carbon were 9.86%, 48.32%, 16.32% and 25.50% respectively. While calorific value of sludge was 2435.45 Kcal/Kg. Sludge compaction shows sludge volume index (SVI) and dryness of sludge were 56.67 ml/g and 9% respectively. The settling study of sludge was carried out for treated effluent at different pH and filterability of sludge was checked at optimum pH. Further analytical study of sludge was also performed by Fourier Transform Infrared Spectroscopy (FTIR), Energy Dispersive X-Ray Spectroscopy (EDX) and X-Ray Diffraction (XRD) analysis.