Abstract:The flow condensation heat transfer coefficient of R134a inside two helical micro-fin tubes with outer diameter of 6.35 mm and helical angles of 18o and 28o respectively were experimentally studied at a high mass flux ranging from 500 to 1100 kg m−2 s−1. The condensation temperatures are 35°C, 40°C and 45°C, and the vapor qualities ranges from 0.95 to 1.00 at the inlet section and from 0.00 to 0.05 at the outlet section. Experimental results show that there are annular and intermittent flow regimes inside the tube under experimental conditions, the ratio of annular flow region to the total heat transfer region is about 70%. The liquid film flow changes from rotational flow to coexistence of rotational and horizontal flows when the vapor quality is 0.475±0.08, 0.486±0.06 and 0.521±0.05, respectively and the corresponding saturation temperature is 35°C, 40°C and 45°C. Based on the experimental data, the heat transfer coefficient increases with increasing mass flux and fin helical angle, and with decreasing saturation temperature and Reynolds number of cooling water. In addition, the heat transfer coefficient of annular flow is greater than that of intermittent flow, in other words, the heat transfer coefficient increases with increasing vapor quality. The heat transfer coefficient obtained at high mass flux was compared with the calculated data of some published correlations used at low mass flux. It was found that most correlations underestimate the experimental heat transfer coefficient inside the micro-fin tube, and these prediction deviation increases with increasing mass flux and fin helical angle. By introducing some dimensionless numbers as well as considering the flow mechanism of liquid film inside the tube, two heat transfer coefficient correlations were proposed based on the experimental data. The ratio of liquid film thickness to fin height was used to characterize whether the liquid film flow is rotational flow or coexistence of rotational and horizontal flows in the proposed correlation, which shows a better prediction accuracy with a mean deviation of less than 7.3%.

Determination of Cooling Intensity Using Transient Heat Transfer Technique at Gas Quenching in Vacuum Heat Treating Furnace

Numerical Simulation of Flow Field and Temperature Field in the Vacuum High Pressure Gas Quenching Furnace

Influencing Factors of Heat Transfer Coefficient in Air and Gas Quenching

Numerical Simulation of Gas Quenching Process of Workpiece

Research on the Cooling Characteristic and Heat Transfer Coefficient of Dynamic Quenchant

Experimental Study of Condensation Heat Transfer of R134a Inside the Micro-Fin Tubes at High Mass Flux

Comparison of Surface Heat-Transfer Coefficients Between Various Diameter Cylinders During Rapid Cooling

Experimental study of heat-transfer coefficient of Al-Zn-Mg-Cu ultra-thick hot plate during multi-stage quenching

Evaluation of interfacial heat transfer coefficient based on the experiment and numerical simulation in the air-cooling process

Numerical simulation of high pressure gas quenching of H13 steel

Numerical Simulation of High Pressure Gas Quenching Process

Homogenisation of Heat Treatment Process in High Pressure Gas Quenching

A FEM-Based Inverse Calculation Method for Determination of Heat Transfer Coefficient in Liquid Quenching Process

A Study of a Two-Phase Heat Transfer Mechanism in a Vertical Sintering Cooling Furnace

Combined CFD and Heat Treatment Simulation of High-Pressure Gas Quenching Process

The Measurement and Calculation of Heat Transfer Coefficient under Different Cooling Conditions

An Experimental Study of Heat Transfer During Forced Air Convection

Characteristic evaluation of cooling technique using liquid nitrogen and metal porous media

Application of transient nonlinear thermal analysis on quenching of hot die steel

Heat transfer coefficient study for air quenching by expenriment and CFD modeling

Numerical Simulation of Convective Heat Transfer for an Internally Cooled Gas Turbine Using Liquid Metal