Abstract:From recent research, lignocellulosic materials assert themselves as good precursors for the manufacture of highly carbonaceous and porous materials. Hence, the perspective of this work is the preparation of the low-cost activated carbons (ACs) based on puck shells (Afrostyrax lepidophyllus) with a large surface area. To achieve this, chemical activation using phosphoric acid and sodium hydroxide as an activating agent was carried out. The response surface methodology through Box-Behnken design was used to optimize the preparation conditions. Box-Behnken design was used to optimize the preparation conditions. The factors whose influences have been studied are the concentration of activating agent (0.5-1.5 mol l-1), the carbonization temperature (300-500°C) and the residence time (30-100 min). The AC obtained by phosphoric acid was named CRP and impregnated with sodium hydroxide CRB. The ideal conditions for the preparation of the ACs obtained from the maximum iodine number (647.29 for CRP and 575.15 mg g-1 for CRB) were: 1.5 mol l-1 for the concentration of activating agent at a carbonization temperature of 500°C during 62 min for CRP and 0.85 mol l-1 for the concentration of activating agent at a carbonization temperature of 500°C during 59 min for CRB. These two materials prepared were characterized by several techniques pH at the point of zero charge (pHpzc), Boehm titration, Fourier transform infrared spectroscopy, XRD analysis, BET method, Raman spectroscopy and scanning electron microscopy, which confirmed the acidic nature of CRP and the basic nature of CRB carbons. The specific surface of the micropores was 509.05 and 27.53 m2 g-1, respectively. It provides a new valorization of agricultural waste for the preparation of effective-cost microporous ACs as an adsorbent that can be applied in water treatment industries.

Preparation and characterization of highly surface area activated carbons followed type IV from marine red alga (Pterocladia capillacea) by zinc chloride activation

Preparation, characterization and adsorption performance of high surface area biomass-based activated carbons

Preparation of High-Surface-Area Activated Carbon from Zizania Latifolia Leaves by One-Step Activation with K2co3/Rarefied Air

Preparation of green alga-based activated carbon with lower impregnation ratio and less activation time by potassium tartrate for adsorption of chloramphenicol

Characterization of activated carbons prepared from sugarcane bagasse by ZnCl2 activation

Production of High Surface Area Activated Carbon from Peanut Shell by Chemical Activation with Zinc Chloride: Optimisation and Characterization

Preparation of High-Surface-Area Activated Carbon from Coconut Shell Fibers

Preparation of biomass-based activated carbon with high-mesoporosity by direct zinc chloride activation

Preparation of High Surface Area Activated Carbons from Luffa Cylindrical Sponge by KOH Activation

Preparation of Activated Carbons from Wet Activated Sludge by Direct Chemical Activation.

Preparation of high specific surface area activated carbon from walnut shells by microwave-induced KOH activation

Dye Removal of Activated Carbons Prepared from NaOH-pretreated Rice Husks by Low-Temperature Solution-Processed Carbonization and H3PO4 Activation

Preparation of High Surface Area Activated Carbon from Petroleum Green Coke

Optimized preparation of activated carbon with high porosities based on puck shells (Afrostyrax lepidophyllus) by response surface methodology and physico-chemical characterization

Microporous activated carbon prepared from luffa cylindrical sponge by chemical activation with zinc chloride

Preparation and Characterization of Polymer-Based Spherical Activated Carbons

Boosting the adsorption capacity of activated carbon prepared from Amygdalus communis shells using physicochemical co-activation method

Methods for preparation and activation of activated carbon: a review

Porous ZnCl2-Activated Carbon from Shaddock Peel: Methylene Blue Adsorption Behavior

High-surface-area porous carbons produced by the mild KOH activation of a chitosan hydrochar and their CO2 capture

Microporous Activated Carbon from Pisum sativum Pods Using Various Activation Methods and Tested for Adsorption of Acid Orange 7 Dye from Water