Abstract:The increase in the thermal protection level of the existing buildings enclosing structures, due to the need to comply with the current norms of building heat engineering requirements, leads to increasing in the part of heat losses in the thermal balance of a building due to infiltration and exhaust ventilation operation. After exhaustion of the possibilities for the implementation of technical measures to reduce energy costs by changing in volumetric planning solutions and insulating building envelopes further decreasing heat consumption level should be associated with the use of the secondary and renewable resources potential. The paper presents the results of assessing the technical and economic feasibility of using the exhaust air thermal potential for heating the supply air in the forced supply-and-exhaust ventilation system of a building taking as a low-capacity unit as an example. For a counterflow air-to-air recuperative type heat utilizer finned with ribbed heat pipes in the form of a plurality of continuous sheets, the influence of changes in the physical properties of the exhaust air during the phase transition of the water vapor contained in it into a liquid state on the heat exchanger-utilizer performance and characteristics of its efficiency has been established. The conditions of heat exchange are determined (without condensate, with condensate in the part of the heat exchanger-utilizer, with condensate in the entire heat exchanger-utilizer and with the risk of icing) in the supply air temperature range from (–26) to (+8) °C for three variants of its operation with a balance of the nominal amount of exhaust and supply air and with two variants of imbalance. Variants with imbalances have been investigated in order to find possible combinations of supply and exhaust air temperatures, at which there would be no phase transition of water vapor in the exhaust air flow to the liquid state in the entire volume of the heat utilizer, which would eliminate the need for measures to collect and remove condensate and preventing it from freezing.

Thermal efficiency evaluation for multisection heat exchange equipment in heat power installations

Improvement of Thermal Performance of Novel Heat Exchanger with Latent Heat Storage

Thermodynamic evaluation of shell and tube heat exchanger through advanced exergy analysis

Recuperative Heat Exchanger-Utilizer Thermodynamic Modes in Low Capacity Supply-and-Exhaust Ventilation Unit

Improvement of heat exchanger efficiency by using hydraulic and thermal entrance regions

Thermal plants operational efficiency improvement

Thermal efficiency of environmentally friendly closed cooling systems of marine power plants

Computational parametric study on efficiency of low boiling point fluid plants under heat exchange process intensification

EXPERIMENTAL STUDY OF HEAT TECHNICAL PARAMETERS OF A SHELL AND TUBE HEAT EXCHANGER WITH A SPIRAL COIL

PARAMETRIC OPTIMIZATION OF HYDRODYNAMIC AND THERMAL PARAMETERS OF HEAT EXCHANGE EQUIPMENT BASED ON SIMILARITY THEORY AND DIMENSIONAL ANALYSIS

Differences and Relations of Objectives, Constraints, and Decision Parameters in the Optimization of Individual Heat Exchangers and Thermal Systems

Effectiveness–thermal Resistance Method for Heat Exchanger Design and Analysis

A Review of Industrial Heat Exchange Optimization

Efficiency of Heat Transfer Surfaces Using the Method of Effective Parameters

THERMODYNAMIC OPTIMIZATION OF COUPLED HEAT WORK CONVERSION AND HEAT TRANSFER ENERGY SYSTEMS BY APPLYING INVERSE PROBLEM AND VARIATION METHOD

Analysis and optimization of heat transfer performance of multi-stage tower-type direct contact heat exchangers in waste heat recovery

Investigation of the thermal and hydraulic properties of a novel heat exchanger for smart heat supply systems

HEAT EXCHANGER STUDY AND OPTIMIZATION APPROACH FOR ENGINE EFFICIENCY IMPROVEMENT

On the mathematic simulation of the energy efficiency for heat exchangers with the systems of impingement plane-parallel jets

Research of variable characteristics of heat exchange equipment

A novel transfer matrix-based method for steady-state modeling and analysis of thermal systems