Abstract:A novel plasma-driven catalysis (PDC) reactor with special structure was proposed to remove vehicle exhaust gas. The PDC reactor which consisted of three quartz tubes and two copper electrodes was a coaxial dielectric barrier discharge (DBD) reactor. The inner and outer electrodes firmly surrounded the outer surface of the corresponding dielectric barrier layer in a spiral way, respectively. Nano-titanium dioxide (TiO2) film prepared by radiofrequency (RF) magnetron sputtering was coated on the outer wall of the middle quartz tube, separating the catalyst from the high voltage electrode. The spiral electrodes were designed to avoid overheating of microdischarges inside the PDC reactor. Continuous operation tests indicated that stable performance without deterioration of catalytic activity could last for more than 25 h. To verify the effectiveness of the PDC reactor, a non-thermal plasma(NTP) reactor was employed, which has the same structure as the PDC reactor but without the catalyst. The real vehicle exhaust gas was introduced into the PDC reactor and NTP reactor, respectively. After the treatment, compared with the result from NTP, the concentration of HC in the vehicle exhaust gas treated by PDC reactor reduced far more obviously while that of NO decreased only a little. Moreover, this result was explained through optical emission spectrum. The O emission lines can be observed between 870 nm and 960 nm for wavelength in PDC reactor. Together with previous studies, it could be hypothesized that O derived from catalytically O-3 destruction by catalyst might make a significant contribution to the much higher HC removal efficiency by PDC reactor. A series of complex chemical reactions caused by the multi-components mixture in real vehicle exhaust reduced NO removal efficiency. A controllable system with a real-time feedback module for the PDC reactor was proposed to further improve the ability of removing real vehicle exhaust gas.

New Experiment of Diesel Exhaust Treatment by Atmospheric Pressure Plasma–Wood Fiber Combination

Non-thermal lasma assisted incineration of particulate matter

Characteristics of Back Corona Discharge in a Honeycomb Catalyst and Its Application for Treatment of Volatile Organic Compounds.

Removal of Dilute VOCs in Air by Post-Plasma Catalysis over Ag-based Composite Oxide Catalysts

Fundamentals and Environmental Applications of Non-thermal Plasmas: Multi-pollutants Emission Control from Coal-Fired Flue Gas

An investigation of the treatment of particulate matter from gasoline engine exhaust using non-thermal plasma

A Novel Four-Way Plasma-Catalytic Approach for the after Treatment of Diesel Engine Exhausts

Optimization for Plasma-facilitated Catalytic Reduction of NO_x

Vehicle Exhaust Gas Clearance By Low Temperature Plasma-Driven Nano-Titanium Dioxide Film Prepared By Radiofrequency Magnetron Sputtering

Nonthermal plasma: An emerging innovative technology for the efficient removal of cooking fumes

The Prototype of Non-thermal Plasma After treatment System for Simultaneous Reduction of Nitrogen Oxide Emission in Flue Gas

Role of Nitrogen-Containing Organic Compound in Plasma Exhaust Treatment

Nitrogen oxide removal by non-thermal plasma for marine diesel engines

Influences of Water Vapor and CO2 on NOx Removal by Plasma-facilitated Selective Catalytic Reduction

Effect of gas temperature on carbon soot oxidation via non-thermal plasma: two-dimensional numerical study integrating reactive flow and discharge models

Effect of nonthermal plasma with different ozone concentrations on the oxidation and removal of different components in particulate matter

Plasma treatment on flame soot: view from nanostructure and reactivity of soot

NOx removal by non-thermal plasma reduction: experimental and theoretical investigations

Sustainable Removal of Particulate Matter from Diesel Engine Exhaust at Low Temperature Using a Plasma-Catalytic Method

Plasma-enhanced electrostatic precipitation of diesel exhaust particulates using nanosecond high voltage pulse discharge for mobile source emission control

Experimental Study of Effects of Non-Thermal Plasma on Exhaust PM Quantity and Mass in Diesel Engine