Abstract:In order to study the flow characteristics of a nozzle with large expansion ratio and its influence on the force on the nozzle, ground cold flow test research and a fluid–structure coupling simulation analysis were carried out (maximum expansion ratio ε = 30.25). The variation and pulsation characteristics of the pressure near the measuring point area and the inlet pressure were obtained through experiments. Through the analysis of the peak-to-peak value and average value, it was found that the average pressure after separation increases by 90%, but the peak-to-peak value increases by about five times, indicating that the pressure fluctuation after separation is much larger than before separation. The separation flow field under cold flow conditions was simulated using the CFD commercial calculation software Fluent to verify the correctness of the numerical calculations. The fluid–structure coupling analysis was carried out on a large expansion ratio (maximum expansion ratio ε = 48) full-scale nozzle, and the structural deformation characteristics of the nozzle under the separation conditions were studied. The research results show that flow separation occurs in the nozzle with a large expansion ratio under ground conditions. Before the separation point, the pressure pulsation on the nozzle wall is small, and the turbulent pulsation effect is weak. After the separation point, the pressure pulsation increases, and the turbulent pulsation effect is enhanced. When the total pressure decreases, the separation area of the nozzle increases, and the separation flow field presents a strong asymmetry. Reducing the total inlet pressure by half resulted in approximately 50 times the lateral load. Under the combined influence of the ground conditions and low total pressure, the large lateral load caused by the asymmetry of the separation flow field will cause the deformation of the nozzle structure to increase by 5.5 times. This research provides an important reference for the design and experiment of nozzles with a large expansion ratio.

Numerical Simulation on Cold-Flow Impact of the Soft Pulse Separation Device in Dual Pulse Solid Rocket Motor

Numerical Simulation of the Performance of the Sc-89 Jet Impact System

Numerical simulation research of high altitude reverse jet flow for stage separation of missile

Research on the Safety of Long Term Storage Solid Rocket Motor with Debonded Layer

Numerical Simulation Coupling on Fluid Flow and Heat Transfer in Nozzle and Equipment Cabin of Solid Rocket Motor during Operation Process

Study on Separation Characteristics of Nozzles with Large Expansion Ratio of Solid Rocket Motors

Numerical analysis for two-phase flow in dual-thrust chamber with finocyl grain

Investigation on metal diaphragm of pulse separation device in dual-pulse solid rocket motor

Simulation and Application of a New Multiphase Flow Ablation Test System for Thermal Protection Materials Based on Liquid Rocket Engine

Numerical Study of Flat Plate Impact on Water Using a Compressible CIP–IBM–Based Model

Modeling and Analysis of Fluid-Solid Coupling Heat Transfer and Fluid Flow in Transonic Nozzle

Simulation of Hard-Soft Material Interaction under Impact Loading Employing the Material Point Method

Numerical Study on the Influence of Separation Time Sequence on the Initial Thermal Separation

Shock Wave and Aeroelastic Coupling in Overexpanded Nozzle

Numerical Simulation of Inner Flow Field of a Pintle Injector Variable Thrust Rocket Engine

Numerical Simulation on Effects of Flight Parameters on Internal Flow of Jet Vector Nozzle

Numerical simulation on high-speed and heavy-load wear behavior of CoCrNi and CoCrFeMnNi alloys

Numerical Simulation of the Stress-Strain State of the Rocket Retention Module

Numerical investigation of vented plume into a supersonic flow in the early stage of rocket hot separation

Strength Check for a Solid Rocket Motor Shell based on Integrated Joint Simulation

Finite Element Simulation on Jet Flow of SDP45 Type Peroration Bullet