ASSESSMENT OF THE BEARING CAPACITY OF THE TUNNEL UNDERPASS MADE OF METAL CORRUGATED STRUCTURES DURING DYNAMIC LOADS OF RAILWAY TRANSPORT

V. V. KOVALCHUK
DOI: https://doi.org/10.15802/bttrp2020/205006
2020-06-07
Abstract:Purpose . The purpose of this work is to determine the load-bearing capacity of metal corrugated structures of a tunnel underpass with a large cross-section under the influence of dynamic loads from railway transport. Such studies are necessary to substantiate the possibility of using corrugated metal structures in the body of a railway track embankment. Methodology . Determination of the bearing capacity of a tunnel underpass was carried out with the help of an advanced analytical method of estimation of the bearing capacity of metal corrugated structures with large cross-section (more than 6.0 m). Findings . The results of multivariate calculations of metal corrugated structures of a tunnel underpass showed that the maximum stresses in the structure occur when locomotive 2M62 passes a section of the railway track and they correspond to 145.45 MPa, while the coefficient of plastic hinge is 0 . 41. The calculations of the bearing capacity of metal corrugated structures of the tunnel overpass under the action of moving transport units show that the metal of the corrugated structure operates in the elastic stage and has a sufficient margin of bearing capacity. Dynamic tests of metal corrugated structures of an underpass from the action of moving transport units show that the metal of a corrugated structure works at the elastic stage and has a 60   % margin of bearing capacity . Originality . For the first time, the load-bearing capacity of a tunnel underpass made of corrugated metal structures with large cross-sections was evaluated during its interaction with soil backfill, with respect to the degree of ground backfill compaction and the magnitude of the dynamic load from the rolling stock. Practical  value . The obtained results of the stress-strain state of a tunnel underpass can be useful for project organizations engaged in calculation of similar structures in the body of the railway track. Corrugated metal structures can be used in railway construction in the form of small bridges, culverts and underpasses with cross-sections up to 14.0 m.
What problem does this paper attempt to address?