A fundamental study on dynamic response of tunnel reinforcement structure for high speed railway

T. Kameda,T. Nishioka
DOI: https://doi.org/10.1201/9780203746653-60
2017-11-22
Abstract:Recently, there have been some reports of deteriorated concrete linings in railroad tunnels. In order to protect train tracks from falling debris, the installation of reinforcement structure is proposed, which makes possible the installation work at night without suspending train services. Therefore, this proposal should assume the situations where the reinforcement structure would be left unfinished by some reason. In this study, a numerical analysis was carried out on the safety of trains passing through the tunnel without backfilling being conducted, using the measurement data of pneumatic pressure fluctuation and vibration. The analysis results confirmed that the proposed reinforcement structure maintains sufficient safety even in an unfinished condition and also suggested that it is desirable to install displacement-restricting spacers on the ends of the structure to prevent vibration. This chapter carries out a numerical analysis on the safety of trains passing through the tunnel without backfilling being conducted, using the measurement data of pneumatic pressure fluctuation and vibration. The analysis results confirmed that the proposed reinforcement structure maintains sufficient safety even in an unfinished condition and also suggested that it is desirable to install displacement-restricting spacers on the ends of the structure to prevent vibration. In order to consider the effect of the vibration by train passage in numerical analysis, the acceleration time series is required as the external excitation source. To measure the acceleration of vibration caused by the passage of a train, acceleration meters were installed immediately under the track and at the bottom part of the tunnel wall. The chapter concludes that the proposed reinforcement structure was proven able to maintain its minimum required safety against the passage of a train in the daytime even with insufficient backfilling.
What problem does this paper attempt to address?