Abstract:We developed new interatomic potentials, based on the second nearest-neighbor modified embedded-atom method (2NN-MEAM) formalism, for Ti, Ni, and the binary Ti–Ni system. These potentials were fit to melting points, latent heats, the binary phase diagrams for the Ti rich and Ni rich regions, and the liquid phase enthalpy of mixing for binary alloys, therefore they are particularly suited for calculations of crystal-melt (CM) interface thermodynamic and transport properties. The accuracy of the potentials for pure Ti and pure Ni were tested against both 0 K and high temperature properties by comparing various properties obtained from experiments or density functional theory calculations including structural properties, elastic constants, point-defect properties, surface energies, temperatures and enthalpies of phase transformations, and diffusivity and viscosity in the liquid phase. The fitted binary potential for Ti–Ni was also tested against various non-fitted properties at 0 K and high temperatures including lattice parameters, formation energies of different intermetallic compounds, and the temperature dependence of liquid density at various concentrations. The CM interfacial free energies obtained from simulations, based on the newly developed Ti–Ni potential, show that the bcc alloys tend to have smaller anisotropy compared with fcc alloys which is consistent with the finding from the previous studies comparing single component bcc and fcc materials. Moreover, the interfacial free energy and its anisotropy for Ti-2 atom% Ni were also used to parameterize a 2D phase field (PF) model utilized in solidification simulations. The PF simulation predictions of microstructure development during solidification are in good agreement with a geometric model for dendrite primary arm spacing.

Parameters (σ, ε) of Lennard-Jones for Fe, Ni, Pb for Potential and Cr based on Melting Point Values Using the Molecular Dynamics Method of the Lammps Program

Solid−Liquid Interfacial Energy and Melting Properties of Nickel under Pressure from Molecular Dynamics

Molecular Dynamics Simulations Of The Melting Curve Of Tantalum Under Pressure

Thermoelastic Properties of Nickel from Molecular Dynamic Simulations

Molecular Dynamics Study of the Melting Curve of Niti Alloy under Pressure

Energy Cohesive Calculation for Some Pure Metals Using the Lennard-Jones Potential in Lammps Molecular Dynamics

Interatomic Potential for Fe–Cr–Ni–N System Based on the Second Nearest-Neighbor Modified Embedded-Atom Method

Modified embedded-atom method potential for high-temperature crystal-melt properties of Ti–Ni alloys and its application to phase field simulation of solidification

Interatomic Potential Fitted for Lead

Evaluation of melting behaviour of Nickel, Titanium, and NiTi alloy using EAM and MEAM type potential

High pressure melt line of nickel using a generalized embedded atomic method potential

Molecular Dynamics Simulations for Melting of Palladium Nanoclusters and Nanowires

First-principle and molecular dynamics calculations for physical properties of Ni–Sn alloy system

Accurate simulation of surfaces and interfaces of ten FCC metals and steel using Lennard–Jones potentials

Thermal Properties Investigation of FeCr Alloy Using Lammps Simulation: A Preliminary Study

Molecular Dynamics Simulations of Melting Iron Nanoparticles with/without Defects Using a Reaxff Reactive Force Field

The Melting Point of Lithium: an Orbital-Free First-Principles Molecular Dynamics Study

The role of chromium and nickel on the thermal and mechanical properties of FeNiCr austenitic stainless steels under high pressure and temperature: a molecular dynamics study

Predicting the Melting Temperatures of Bulk Materials

Molecular Dynamics Simulation and Mechanical Properties Analysis of Ni-Fe Alloy under Uniaxial Stretching

Influence of different configurations of Fe nanoparticles on the melting point: a molecular dynamics simulation