Abstract:We investigate the application of embedded atom method (EAM) interatomic potentials in the study of crystallization kinetics from deeply undercooled melts, focusing on the fcc metals Al and Cu. For this application, it is important that the EAM potential accurately reproduces melting properties and liquid structure, in addition to the crystalline properties most commonly fit in its development. To test the accuracy of previously published EAM potentials and to guide the development of new potential in this work, first-principles calculations have been performed and new experimental measurements of the Al and Cu liquid structure factors have been undertaken by X-ray diffraction. We demonstrate that the previously published EAM potentials predict a liquid structure that is too strongly ordered relative to measured diffraction data. We develop new EAM potentials for Al and Cu to improve the agreement with the first-principles and measured liquid diffraction data. Furthermore, we calculate liquid-phase diffusivities and find that this quantity correlates well with the liquid structure. Finally, we perform molecular dynamics simulations of crystal nucleation from the melt during quenching at constant cooling rate. We find that EAM potentials, which predict the same zero-temperature crystal properties but different liquid structures, can lead to quite different crystallization kinetics. More interestingly, we find that two potentials predicting very similar equilibrium solid and liquid properties can still produce very different crystallization kinetics under far-from-equilibrium conditions characteristic of the rapid quenching simulations employed here.

Interatomic Potential Fitted for Lead

Solid−Liquid Interfacial Energy and Melting Properties of Nickel under Pressure from Molecular Dynamics

Different melting behavior of lead surfaces

Accurate Path-Integral Molecular Dynamics Calculation of Aluminum with Improved Empirical Ionic Potentials

Towards atomistic modelling of solid Pb-O formation and dissolution in liquid lead coolant: interatomic potential development

Analysis of semi-empirical interatomic potentials appropriate for simulation of crystalline and liquid Al and Cu

An Improved Modified Embedded-Atom Method Potential to Fit the Properties of Silicon at High Temperature

Development of suitable interatomic potentials for simulation of liquid and amorphous Cu–Zr alloys

An Emb E Dde D-Atom Method Potential for Studying the Properties of Fe-Pb Solid-Liquid Interface

Parameters (σ, ε) of Lennard-Jones for Fe, Ni, Pb for Potential and Cr based on Melting Point Values Using the Molecular Dynamics Method of the Lammps Program

Long-range empirical potential model: extension to hexagonal close-packed metals

Development of interatomic potentials for Fe-Cr-Al alloy with the particle swarm optimization method

A quantitative theory and atomistic simulation study on the soft-sphere crystal-melt interfacial properties. I. Kinetic coefficients

MEAM interatomic potential for thermodynamic and mechanical properties of lithium allotropes

Reconciling simulated melting and ground-state properties of metals with a modified embedded-atom method potential

Generalized correction to embedded-atom potentials for modeling equilibrium and non-equilibrium properties of metals

Crystal Structure Prediction of Binary Alloys via Deep Potential

Modified embedded-atom method interatomic potentials for the Mg-Al alloy system

A high-dimensional neural network potential for molecular dynamics simulations of condensed phase nickel and phase transitions

Molecular dynamics simulations of lead clusters

Empirical-potential Studies on the Structural Properties of Small Silicon Clusters