Abstract:This paper focuses on the mechanisms of combustion noise during the accelerating operation of multi-cylinder diesel engines using testing technology for the transient conditions of IC engines. Based on impact factors, such as the gas dynamic load and cylinder pressure oscillations, tests and analysis of the combustion noise during transient and steady-state conditions for different loads are made on four-cylinder naturally aspirated engines, turbocharged engines, EGR-introduced engines, and high pressure common rail engines. The laws of combustion noise difference for the same engine speed and load are researched during transient and steady-state conditions. It is found that during transient conditions, the maximum pressure rise rate and the high frequency oscillation amplitude of the cylinder pressure are all higher than those observed during steadystate conditions for the same engine speed and load. With their joint action, the combustion noise during transient conditions is greater than that during steady-state conditions. Turbocharging is useful in reducing the combustion noise during transient conditions. Turbocharging has a better effect on the control over the combustion noise during transient conditions with a constant engine speed and an increasing torque than in conditions with a constant torque and an increasing engine speed. One of the main reasons for different control effects on the combustion noise is that turbocharging causes different wall temperatures inside combustion chambers. The introduction of the appropriate EGR is helpful in the reduction of the combustion noise during transient conditions. The key to the control of combustion noise with EGR during transient conditions is whether a real-time adjustment to the EGR rate can be made to achieve the optimization of the EGR rates for different transient conditions. By means of analyzing the differences in the combustion noise between the transient and steady-state conditions for different pilot injection controls, we obtain a strategy for controlling the combustion noise during transient conditions with a pilot injection. Compared with the steady-state conditions, a larger pilot injection quantity and a longer interval between the main injection and pilot injection should be selected for transient conditions, and this is verified through tests.

AUTOMOBILE INTERNAL COMBUSTION ENGINE PRESSURE CHARGING AND GAS-GUIDE LOW FREQUENCY NOISE REDUCTION USING ACTIVE SOUND SOURCES

AUTOMOBILE INTERNAL COMBUSTION ENGINE LOW FREQUENCY NOISE REDUCTION USING ACTIVE NOISE CONTROL SOLUTIONS

An Objective and Subjective Study on Global Active Control of Engine Noise in a Car

Identification and Evaluation of Diesel Engine Noise Source Based on Acoustic Intensity

Influence of the Accelerating Operation Mechanism on the Combustion Noise in DI-diesel Engines

Artificial Engine Sound Synthesis Method for Modification of the Acoustic Characteristics of Electric Vehicles

Analysis on Noise of High Pressure Direct Injection System

Virtual-prototype-based Noise-Reduction Study on Single-Cylinder Diesel Engines

Research on Noise-Reduction of Gasoline Vehicle Intake and Exhaust System

Wave dynamics analysis at the intake of a turbocharged engine: concept proposal of a new active inlet charge air duct for low-speed tuning and high-speed permeability

Integrated Solutions for Noise and Vibration Control in Vehicles

Research on active sound control in EV in-vehicle based on engine order sound fitting

Experimental Investigation on the Relationship Between In-Cylinder Pressure Rise Rate and Combustion Noise of the Diesel Engine

The Reduction of Air-Rush Noise in Plastic Engine Intake Manifolds

Coupled optimization of internal combustion engine radiated noise and interior noise

Study and Development of Subjective Evaluation of Inner Noise Quality and Improvement

A Study on Reducing Vehicle Passing-by Noise by Improving the Intake and Exhaust Systems

Flow Field Simulation and Noise Control of a Twin-Screw Engine-Driven Supercharger

Investigation on Main Noise Sources of Vehicle Gasoline Engine by Sound Intensity Measurement

Noise radiated by electric motors – simulation process and overview of the optimization approaches

Toward a Cylinder Pressure Signals-Based Active Synthesis Algorithm for Engine Sound