Abstract:Flame atomic absorption spectrometry (FAAS) still keeps its importance despite the relatively low sensitivity; because it is a simple and economical technique for determination of metals. In recent years, atom traps have been developed to increase the sensitivity of FAAS. Although the detection limit of FAAS is only at the level of µg/mL, with the use of atom traps it can reach to ng/mL. Slotted quartz tube (SQT) is one of the atom traps used to improve sensitivity. In atom trapping mode of SQT, analyte is trapped on-line in SQT for few minutes using ordinary sample aspiration, followed by the introduction of a small volume of organic solvent to effect the revolatilization and atomization of analyte species resulting in a transient signal. This system is economical, commercially available and easy to use. In this study, a sensitive analytical method was developed for the determination of lead with the help of SQT atom trapping flame atomization (SQT-AT-FAAS). 574 Fold sensitivity enhancement was obtained at a sample suction rate of 3.9 mL/min for 5.0 min trapping period with respect to FAAS. Organic solvent was selected as 40 µL of methyl isobutyl ketone (MIBK). To obtain a further sensitivity enhancement inner surface of SQT was coated with several transition metals. The best sensitivity enhancement, 1650 fold enhancement, was obtained by the Ta-coated SQT-AT-FAAS. In addition, chemical nature of Pb species trapped on quartz and Ta surface, and the chemical nature of Ta on quartz surface were investigated by X-ray photoelectron spectroscopy (XPS) and Raman Spectroscopy. Raman spectrometric results indicate that tantalum is coated on SQT surface in the form of Ta2O5. XPS studies revealed that the oxidation state of Pb in species trapped on both bare and Ta coated SQT surfaces is +2. For the accuracy check, the analyses of standard reference material were performed by use of SCP SCIENCE EnviroMAT Low (EU-L-2) and results for Pb were to be in good agreement with the certified value using SQT-AT-FAAS and Ta coated-SQT.

Zirconium nanoparticles based ligandless dispersive solid phase extraction for the determination of antimony in bergamot and mint tea samples by slotted quartz tube-flame atomic absorption spectrophotometry

Determination of zinc in dried nuts by slotted quartz tube-flame atomic absorption spectrometry (SQT-FAAS) with citric acid-coated magnetic nanoparticle (CAMNP) based solid phase extraction (SPE)

Determination of Silver in Metal Plating Wastewater by Slotted Quartz Tube Flame Atomic Absorption Spectrometry (SQT-FAAS) after Preconcentration with Stearic Acid-Coated Magnetite Nanoparticle-Based Solid-Phase Microextraction (SA-MNP-SPME)

Zirconium Nanoparticles Based Vortex Assisted Ligandless Dispersive Solid Phase Extraction for Trace Determination of Lead in Domestic Wastewater using Flame Atomic Absorption Spectrophotometry

Selective speciation of inorganic antimony on tetraethylenepentamine bonded silica gel column and its determination by graphite furnace atomic absorption spectrometry

Dual extraction based on solid phase extraction and solidified floating organic drop microextraction for speciation of arsenic and its distribution in tea leaves and tea infusion by electrothermal vaporization ICP-MS

Iron (II, III) Oxide/multi-Walled Carbon Nanotube Composite As Solid-Phase Extraction Sorbent Followed by Ultra-High Performance Liquid Chromatography Tandem Mass Spectrometry for Simultaneous Determination of Zearalenone and Type A Trichothecenes in Salviae Miltiorrhizae Radix Et Rhizoma (Danshen).

Lead determination at ng/mL level by flame atomic absorption spectrometry using a tantalum coated slotted quartz tube atom trap

Trace Determination of Rhodium in Coating Wastewater by Vortex Assisted Magnetic Nanoparticle Based Solid Phase Microextraction (MNP-SPME) Combined with Slotted Quartz Tube–Flame Atomic Absorption Spectrometry (SQT-FAAS) with Matrix Matching Calibration

Bi, Fe, and Ti ternary co-doped ZrO2 nanocomposites as a mass spectrometry matrix for the determination of bisphenol A and tetrabromobisphenol A in tea

Solid-phase extraction using multiwalled carbon nanotubes and quinalizarin for preconcentration and determination of trace amounts of some heavy metals in food, water and environmental samples

A new synthesis, characterization and application chelating resin for determination of some trace metals in honey samples by FAAS

Cloud point extraction combined with electrothermal atomic absorption spectrometry for the speciation of antimony(III) and antimony(V) in food packaging materials

An accurate determination method for cobalt in sage tea and cobalamin: Slotted quartz tube-flame atomic absorption spectrometry after preconcentration with switchable liquid-liquid microextraction using a Schiff base

Determination of copper and cobalt in different tea samples at trace levels by FAAS after preconcentration with a novel iron PAMAM-OH-encapsulated magnetic nanoparticle as SPE sorbent

Determination of Perchlorate from Tea Leaves Using Quaternary Ammonium Modified Magnetic Carboxyl-Carbon Nanotubes Followed by Liquid Chromatography-Tandem Quadrupole Mass Spectrometry

Determination of Cobalt (II), Copper (II), Lead (II), and Zinc (II) with Preconcentration by 8-Hydroxyquinoline-Coated Magnetic Nanoparticles (MNPs) and Microinjection Sampling–Flame Atomic Absorption Spectrometry (MIS–FAAS)

Syringe Membrane Micro-Solid-Phase Extraction (SPE) with Flexible Titanium(IV) Oxide@Silica Nanofiber Membrane for the Speciation of Te(IV) and Te(VI) with Graphite Furnace Atomic Absorption Spectrometry (GFAAS)

Ultra-trace determination of arsenic species in environmental waters, food and biological samples using a modified aluminum oxide nanoparticle sorbent and AAS detection after multivariate optimization

Silica-gel Particles Loaded with an Ionic Liquid for Separation of Zr(IV) Prior to Its Determination by ICP-OES

Application of SBA-15/Diphenyl Carbazon/SDS Nanocomposite As Solid-Phase Extractor for Simultaneous Determination of Cu(II) and Zn(II) Ions