Abstract:In an effort to find more cost‐effective and proactive ways to keep bridges in good condition, the use of instrumented vehicles has gained great interest in the last decade. Two bridge components that can wear rapidly are the bearings and the road surface. However, past research on drive‐by monitoring has placed focus mostly on detecting losses of bending stiffness in the bridge deck, while assuming ideal support conditions that may differ from real cases significantly, and ignoring the characterization of the road profile. Even further, the need for specialized vehicles equipped with high‐tech instrumentation, low speeds, or very good road profiles has been a major obstacle preventing its practical implementation. This paper investigates the use of axle accelerations from an ordinary two‐axle vehicle crossing the bridge to quantify the rotational stiffness of the supports and the height of the road irregularities while overcoming the limitations exposed above. In contrast to previous research where the response of the contact point has been derived from other vehicular locations based on complex differential equations of motion, transfer functions are employed here. The key advantage of transfer functions is their simple algebraic form that can be easily calibrated on the field. The road profile is then obtained by subtracting the displacement of the bridge under each axle from the displacement of the contact point. There is one prediction of the road profile per axle but only a unique value of rotational stiffness at each support that will yield the same prediction by both axles. The algorithm is successfully tested with a half‐car traveling at 5, 10, 15, and 20 m/s, over a 15‐m bridge beam model with ISO road classes "A," "B," and "C," for boundary conditions ranging from simply supported to fixed. The solution's robustness to modeling inaccuracies and noisy data is also investigated.

Bridge health monitoring using deflection measurements under random traffic

Damage Identification in Warren Truss Bridges by Two Different Time–Frequency Algorithms

Monitoring bearing damage in bridges using accelerations from a fleet of vehicles, without prior bridge or vehicle information

Using Drive-by Health Monitoring to Detect Bridge Damage Considering Environmental and Operational Effects

Kalman Filter Based Estimation of Neutral Axis Position of Bridge Deck under Traffic Loading

Experimental verification of a data-driven algorithm for drive-by bridge condition monitoring

HEALTH-MONITORING METHOD FOR BRIDGES UNDER ORDINARY TRAFFIC LOADINGS

A bridge dynamic response analysis and load recognition method using traffic imaging

Using Statistical Analysis of an Acceleration-Based Bridge Weigh-In-Motion System for Damage Detection

Dynamic Reliability Assessment of Heavy Vehicle Crossing a Prototype Bridge Deck by Using Simulation Technology and Health Monitoring Data

Vehicle-Assisted Techniques for Health Monitoring of Bridges

Bridge Health Monitoring Using Strain Data and High-Fidelity Finite Element Analysis

A strain sensor based monitoring and damage detection system for a two-span beam bridge

Structural damage identification based on dynamic deflection sensitivity of bridge under vehicle loading

Characterization of the road profile and the rotational stiffness of supports in a bridge based on axle accelerations of a crossing vehicle

Evaluating Probabilistic Traffic Load Effects on Large Bridges Using Long-Term Traffic Monitoring Data

Damage Detection in Bridge Structure Using Vibration Data under Random Travelling Vehicle Loads

Bridge health monitoring system based on vibration measurements

Dynamic Reliability of Continuous Rigid-Frame Bridges under Stochastic Moving Vehicle Loads

Static and dynamic vehicle load identification with lane detection from measured bridge acceleration and inclination responses

A Review of Indirect Bridge Monitoring Using Passing Vehicles