Oxygen‐Assisted Tailoring of Evaporated PbS Hole Transport Layer for Highly Efficient Antimony Sulfide Solar Cells
Jin‐Rui Cai,Zi‐Heng Huang,Wei‐Qin Huang,Ling‐Jie Liu,Hu Li,Li‐Mei Lin,Ya‐Lu Zhan,Ying‐Sen Xia,Shui‐Yuan Chen,Gui‐Lin Chen
DOI: https://doi.org/10.1002/smll.202407246
IF: 13.3
2024-12-02
Small
Abstract:Sb2S3, with its high light absorption (>105 cm−1), suitable bandgap (1.7 eV), and stability, offers 28% theoretical efficiency. This study uses PbS hole transport layers via thermal evaporation, optimized by oxygen doping to refine morphology and energy levels. These advancements suppress recombination, achieving a 6.63% PCE in FTO/CdS/Sb2S3/PbS/carbon solar cells. Antimony sulfide (Sb2S3) is regarded as one of the potential candidates for the next generation of photovoltaic absorber due to its excellent photoelectric properties. However, the selection and optimization of the hole transport layer (HTL) is still a major challenge for efficiency breakthrough of the Sb2S3 solar cells. In this work, lead sulfide (PbS) is deposited as a HTL of the Sb2S3 device by thermal evaporation for the first time. A high quality PbS films is conformally coated on the Sb2S3 rear surface by regulating the feeding amount, which thanks to the mass transfer mechanism of Ostwald ripening by scrutinizing the film growth kinetics. Meanwhile, both the valence band maximum (VBM) and Fermi levels are shifted down by a deliberate oxygen doping under a low vacuum ambient, which effectively reduces the offset between Sb2S3 and carbon electrode and then accelerates hole collection. Finally, it delivers an impressive photovoltaic conversion efficiency of 6.63% for carbon‐based Sb2S3 solar cells, coupled with a Voc of 779 mV, Jsc of 14.9 mA cm−2 and FF of 57.13%, which is 13% higher than that under high vacuum condition.
materials science, multidisciplinary,chemistry, physical,physics, applied, condensed matter,nanoscience & nanotechnology