Effect of solid particles in evaporating hot water tower on bubble movement

Zebin Bao,Yifei Wang,Chenhui Hu,Guangsuo Yu
DOI: https://doi.org/10.1007/s00231-020-02869-y
2020-05-06
Heat and Mass Transfer
Abstract:In this paper, a visualization experiment was conducted for multiphase flow in the evaporating hot water tower. The high-speed camera was used to record the motion of a single bubble above the 3 mm single-hole sieve tray in the hot water tower. The pictures were processed by image processing software to obtain the characteristics of the bubble. In the experiment, non-condensable gas was added to the steam as a carrier of particles. A mixture of gaseous N<sub>2</sub> and N<sub>2</sub>/solid particles was used to study the effect of solid particles on bubble formation, collapse and motion processes. The correlation for the number of transfer units <i>NTU</i><sub><i>L</i></sub> is proposed. The experimental results show that the entire growth cycle of the bubble includes the formation region, the rising region and the oscillation region. The ratio of bubble length to diameter decreases from 1.13 to 0.80 in the formation region and surges to 1.3 in the rising region. The equivalent radius of the bubble increases throughout the entire cycle of motion, with the highest growth rate in the formation region and maximum radius of bubble not exceeding 20 mm. The centroid velocity rate of bubble in the formation region shows an increasing trend, and then fluctuates around 0.4 m/s in the rising region and the oscillation region. When N2 was entrained into the pulverized coal particles, it was found that the proportion of the rising region of the bubble was greatly reduced, and the proportion of the oscillation region increased significantly, which was conducive to the transfer of heat within the tower. The effect is more obvious when steam and nitrogen ratio α is less than 10.
thermodynamics,mechanics
What problem does this paper attempt to address?