Experimental Characterization of the Bubble Neck Formation During Its Growth Process on a Superhydrophobic Surface

Jiejin Cai,Ziqi Gong,Zhihong Tang,Xuezhong Li,Ye Wang,Huaqiang Yin,Xingtuan Yang

DOI: https://doi.org/10.1016/j.nucengdes.2020.110762

IF: 1.7

2020-01-01

Nuclear Engineering and Design

Abstract:Bubble growth is a common phenomenon in nuclear power generation, which is significantly affected by the wettability of the heating surface. In this paper, the bubble growth on the 153.15 degrees superhydrophobic surface was observed by a high-speed camera, and the velocity field of the water surrounding the bubble was also analyzed using particle image velocimetry (PIV). The experimental results show that the special of the bubble growth on the superhydrophobic surface is that it forms a bubble neck. This is because of the superhydrophobic surface affinity for vapor, the surface is covered by a vapor film when heated. The bubble is generated from the film through the neck. Therefore, this paper focuses on the bubble neck formation stage during the bubble growth process. When the surface heating power changes, the time required for bubble growth changes accordingly. But the bubble size is not affected by the heating power. However, the effect of heating power on bubble growth time is mainly at the stage of the vapor film bulging stage, and it also has no effect on the bubble neck formation time. The reason for the above phenomenon is that the neck restricted the amount and rate of vapor entering the bubble. Besides, the velocity field of water is observed and it is found that the annular flow field strengthened the heat transfer and promotes the fracture of the neck.