Abstract:The ability to weld metals and sapphire is widely required in aerospace, micro-electro-mechanical systems and microwave energy delivery devices. The experiments of femtosecond laser welding between sapphire and copper (Cu) were conducted under non-optical contact conditions. And the effect of pre-fabricating a Ti film on the sapphire surface using femtosecond laser on the bonding strength of ssapphire/Cu joint was investigated. The interface of the sapphire/Cu directly welded by femtosecond laser contains a mixture of sapphire and copper, and the shear strength of the sapphire/Cu interface was approximately 46.4 MPa. The results indicated that the laserinduced molten state of sapphire and the laser-ablated copper mixed together at the interface, filling the gaps and forming an effective metallurgical bond. And then, in the case that the Ti film was prepared on the sapphire surface through femtosecond laser-induced backward transfer (LIBT), a Ti transition layer between sapphire and cooper was observed on the bonding interface of the joint, and the shear strength of the joint increased to approximately 115.5 MPa. A mixture of sapphire, copper, titanium, and titanium oxide was observed at the interface of the joint. The Ti layer between sapphire and copper may effectively alleviated residual stresses at the interface and promoted bonding between copper and sapphire, thereby improving the strength of the joint. The methods and results of this study have reference value for the ultrafast laser bonding between other transparent brittle materials and metals.

Two-layer vertical welding of glasses by femtosecond laser through galvo scanner

Welding of Glasses in Optical and Partial-Optical Contact Via Focal Position Adjustment of Femtosecond-Laser Pulses at Moderately High Repetition Rate

High-Strength Welding of Silica Glass Using Double-Pulse Femtosecond Laser under Non-Optical Contact Conditions

Improved Femtosecond Laser Welding of Nonoptical Contact Glass by Pressure and a Water Intermediate Layer

One-step Femtosecond Laser Welding and Internal Machining of Three Glass Substrates

High-quality welding of glass by a femtosecond laser assisted with silver nanofilm

Femtosecond laser Bessel beam welding of transparent to non-transparent materials with large focal-position tolerant zone.

Direct microwelding of dissimilar glass and Kovar alloy without optical contact using femtosecond laser pulses

Microwelding of Glass to Silicon by Green Ultrafast Laser Pulses

Direct Welding of Glass and Metal by 1 Khz Femtosecond Laser Pulses.

Direct joining of quartz glass and copper by nanosecond laser

Mechanism and optimization of femtosecond laser welding fused silica and aluminum

Embedded thin film fabrication via glass welding by an ultrafast laser

Glass Micro Welding in Thermal Accumulation Regime with Using Spatially Shaped Ultrafast Laser

Welding Fused Silica Glass By Picosecond Pulsed Laser with Low Numerical Aperture

Study on Microstructure and Mechanical Properties of Femtosecond Laser Welding of Non-Optical Contact Quartz Glass and Zr-4

The effect of gap on the quality of glass-to-glass welding using a picosecond laser

The characteristics and dynamics of fused silica-aluminum alloy welding during mJ-level femtosecond laser

Realization of Joints of Aluminosilicate Glass and 6061 Aluminum Alloy via Picosecond Laser Welding without Optical Contact

Femtosecond Laser Welding of Sapphire-Copper Using a Thin Film Titanium Interlayer

Glass to aluminum joining by forming a mechanical pin structure using femtosecond laser