Abstract:Purpose The purpose of this paper is to investigate the effects of chloride ion concentration and applied bias voltage on the electrochemical migration (ECM) behavior between Cu and Ag under an NaCl thin electrolyte layer (TEL). Design/methodology/approach A self-made experimental setup for the ECM behavior between Cu and Ag was designed. An HD video measurement microscopy was used to observe the typical dendrite/corrosion morphology and pH distribution. Short-circuit time (SCT), short-circuit current density and the influence of the galvanic effect between Cu and Ag on their ECM behavior were studied by electrochemical tests. The surface morphology and composition of dendrite were characterized by FESEM/EDS. Findings The SCT increased with increasing NaCl concentration but decreased with increasing applied bias voltage, and the SCT between Cu and Ag was less than that between Cu and Cu because their galvanic effect accelerated the dissolution and migration of Cu. When NaCl concentration was less than or equal to 6 mmol/L, cedar-like dendrite was formed, whereas no dendrite formed and only precipitation occurred at high chloride ion concentration (100 mmol/L). The composition of the dendrite between Cu and Ag was copper. Research limitations/implications The significance of this study is to clarify the ECM failure mechanism of printed circuit board (PCB) with an immersion silver surface finish (PCB-ImAg). Practical implications This study provides a basic theoretical basis for the selection of protective measures and metal coatings for PCB. Social implications The social implication of this study is to predict the service life of PCB. Originality/value The ECM behavior of dissimilar metals under a TEL was investigated, the influence of the galvanic effect between them on their ECM was discussed, and the SCT increased with increasing NaCl concentration.

Corrosion behavior of immersion silver printed circuit board copper under a thin electrolyte layer

Electrochemical migration behavior between Cu and Ag under a thin electrolyte layer containing chloride

Corrosion Behaviour of Copper under Chloride-Containing Thin Electrolyte Layer

Corrosion Behavior of Pure Zinc and Its Alloy under Thin Electrolyte Layer

Interaction between PCB-Cu corrosion and electrochemical migration under the Coupling of electric field and thin liquid film

Corrosion Behavior of Aluminum Bronze under Thin Electrolyte Layers Containing Artificial Seawater

Corrosion Behavior of Q235 in Simulated Natural Environment by Electrochemical Technology

In-Situ Investigation of Atmospheric Corrosion Behavior of Bronze under Thin Electrolyte Layers Using Electrochemical Technique

Corrosion Behavior of Bronze under Organic Acid‐containing Thin Electrolyte Layer

Bioinspired corrosion inhibition for printed circuit board: implications of dendritic Sn-ZIF-LIS coating on Cu metal

Corrosion Behavior of 907 Steel under Thin Electrolyte Layers of Artificial Seawater

Electrochemical Corrosion and Protection of Copper Foil Treated by Surface Siloxane Filming

Influence of Thermal Effect on Electrochemical Corrosion Behavior of T2 Copper in Simulated Seawater Environment

Electrochemical impedance spectroscopy of metals covered with a thin electrolyte layer

Investigation of Az91d Magnesium Alloy Corrosion Behavior under Thin Electrolyte Layer Using Nondestructive Electrochemical Techniques

Effect of Sulphate on the Corrosion Behavior of Bronze under a Chloride‐containing Thin Electrolyte Layer

Electrochemical Investigation Cu Corrosion Behaviour of Electronic Circuit Board in Base Electrolyte

Electrochemical Study Of The Corrosion Behavior Of Bronze Under Acetic Acid-Containing Thin Electrolyte Layers

The Adsorption of the Thiobacillus Ferrooxidans on the Printed Circuit Board Scrap and Bioleaching of Cu

Study on fine lines and undercut suppression of printed circuit board prepared by electrolytic etching

Galvanic corrosion behaviors of Cu connected to Au on a printed circuit board in ammonia solution