Abstract:The roughness coefficient is an important influencing factor of the joint shear strength. However, the research of size effect on joint roughness coefficient has not gained great progress due to surface morphology complexity of rock joint. This paper summarizes three methods to obtain joint roughness coefficient, i. e. standard profile comparison method, theoretical equation method and inverse analysis method, and then analyzes some existing problems and difficulties on studying size effect on joint roughness coefficient. In order to achieve the relationship between joint roughness coefficient and sample size, the ratios of raw materials such as medium sand, silica fume, cement, non-air entraining naphthalene super-plasticizer, are firstly investigated. Then rock materials for simulation are obtained, in which physico-mechanical properties are similar to calcareous slate. Finally, eight groups of rock joints with 176 pairs of different sizes and roughness are made through molds in preparation process. In addition, the roughness coefficients of rock joints are tested by homemade push-pull shear apparatus and experimental data are further analyzed. The results show that statistical mean values of joint roughness coefficient generally decrease with the increase of sample size. However, the size effect tests on the specific rock joints need to be performed through push-pull shear strength testing method. It is found that size effect variations calculated by Barton formula are in good agreement with experimental results, whereas the theoretical and experimental values are different. In particular, when the size of sample is smaller, the differences are greater. Furthermore, rock roughness coefficients even with specific joint surfaces are various and the roughness coefficients of large size rock joint should be comprehensively judged according to the surface morphology and distribution.

Representative Sample Sampling Method for Size Effect Experiment of Jointed Rock Mass

A New Representative Sampling Method for Series Size Rock Joint Surfaces

EXPERIMENTAL STUDY OF SAMPLING REPRESENTATIVENESS OF STRUCTURAL PLANE OF ROCK MODEL

New Statistical Quantification Method for the Size Effect Behavior of Rock Mass Using Compressive Strength As an Example

Study on the Influencing Factors of Sampling Representativeness of Rock Joints

An experimental study of size effect of roughness coefficient on rock joint using push-pull apparatus

On Size Effect of Rock Joints Roughness Based on Varied Statistical Methods

Experimental Technology for the Shear Strength of the Series-Scale Rock Joint Model

Study of Size Effect on the Anisotropic Variation Coefficient of Rock Joints

A New Method for Determination of Joint Roughness Coefficient of Rock Joints

Correlation Between the Joint Roughness Coefficient and Rock Joint Statistical Parameters at Different Sampling Intervals

Experimental and Numerical Investigation on Shear Failure Behavior of Rock-like Samples Containing Multiple Non-Persistent Joints

Study Of Shear Strength Characteristics Of Simulation Rock Structural Planes Based On Multi-Size Direct Shear Tests

Stability Analysis of Jointed Rock Mass in Large Underground Caverns Based on Multi-Scale Analysis Method

Representative sampling method for laboratory testing on shear strength of rock joints

A study about the influence of joint roughness on the volume of rock blocks

Revisiting Scale Effect on Joint Roughness Coefficient and Shear Strength Considering Sampling Methods and Geometric Characteristics

3D Morphology Reconstruction of Rock Joints from 2D Profile Measurement by a Profilograph

On the Simulative Experimental Study of Mechanical Properties of Stratified Rock Mass

PRECISE MEASUREMENT AND QUANTIZATION ABOUT JOINTS OF ROCK MASSES

A New Method to Investigate the Size Effect and Anisotropy of Mechanical Properties of Columnar Jointed Rock Mass