Abstract:Spline-gear-shaft (SGF), which is mainly composed of gear and spline shaft, is an important transmission system of RAT (driving the generator to output power with ram air). And its dynamic characteristics affect performance of RAT greatly. In this situation, gear coupling and spline coupling, must be taken into account when analyzing dynamics characteristics of SGF. The misalignment of axis for internal and external spline is inevitable owing to mass eccentricity and unconstrained in axial direction in a high-speed operation. Consequently, the dynamic model of SGF is established considering gear coupling and spline coupling based on whole transfer matrix method (WTMM) in this paper. In addition, numerical calculation method of meshing force for spline teeth under the condition of misalignment is presented considering the distribution force on contact surface of spline teeth in this paper, based on this, the coupled transfer matrix of misaligned spline coupling is established and the dynamic characteristics of SGF is analyzed using whole transfer matrix method with Riccati (WTMMR). The test experiments of dynamic characteristics for SGF are carried out by using portable vibration monitoring analyzer in this paper, furthermore, the time-frequency characteristics of SGF are analyzed through the analysis and processing of acceleration signal. The orders of magnitude for the first four natural frequencies with WTMMR are respectively consistent with experiment results, and the relative error is in the accepted range. Therefore, the correctness of solving meshing force and WTMMR for SGF are all verified. Moreover, it also shows that WTMMR is suitable for the analysis of complex coupled systems SGF and provides a new thought for dynamic analysis of complex shafting and promotes dynamic analysis to efficient and streamlined development.

Spline drive transient analysis

Dynamic modelling of gear–spline system with nonuniform spline clearance and wear evolution of spline

Simulation and Verification of Involute Spline Tooth Surface Wear before and after Carburizing Based on Energy Dissipation Method

Dynamic Characteristics and Load Coefficient Analysis of Involute Spline Couplings

Study on Spline Stress of Separator Plates in a Wet Multi-Plate Clutch

Investigation on Coupling Effects Between Surface Wear and Dynamics in A Spur Gear System

Deformation of Harmonic Drive in Transmission State Based on Contact Analysis with Shell Element Tooth

Analysis and Simulation on Dynamic Stress of Tracked Vehicle Sprocket Based on Rigid-Flexible Coupling

A Study on the Influence of Nonlinear Vibration on Fretting Damage of Involute Spline Pairs in Aero-Engines

Analysis of the Wear Mechanism of High-Speed Transmission and the Prediction Model.

Research on dynamic load spectrum of electric vehicle transmission system based on underdamping characteristic

Stress Analysis and Strength Calculation Methods of Involute Spline Couplings

Analysis of Vibration Characteristics of Face Gear powering-split Transmission System

Non-linear dynamic response of misaligned spline coupling: Theoretical modeling and experimental investigation

Bifurcation and Chaos of a Spur Gear Transmission System With Non-Uniform Wear

Simulation and Test of Spindle Mode of Planetary Variable Speed Device

Analysis of the Partial Axial Load of a Very Thin-Walled Spur-Gear (Flexspline) of a Harmonic Drive

Prediction and Experimental Validation of Aviation Floating Involute Spline

Modification methodology of fretting wear in involute spline

Non-uniform wear evolution of gear tooth surface under complicated excitations in a locomotive

Analysis of dynamic characteristic for misalignment-spline gear shaft based on whole transfer matrix method