Abstract:Reactivity controlled compression ignition (RCCI) combustion is a advanced low temperature combustion concept to reduce CO 2 and brake the trade-off between NOx and PM emissions for next generation compression ignition (CI) engines. However, it leads to the more complex multi-stage heat release in diesel/natural gas (NG) dual fuel engines and is criticized for extra-high methane and carbon monoxide emissions. Using the existing methods, it is difficult to effectively quantify the contribution of the accumulated heat release (AHR) at each stage to the whole combustion process and to create their relevance to the performance and emissions in the RCCI engines. In this paper, experiments were conducted on a ship diesel/NG dual-fuel engine at a load of 25 %. A new identification and quantitative analysis method of multi-stage heat release is proposed, and the coupling effects of the diesel split injection parameters on the multi-stage heat release and performance in the RCCI engine were revealed. The results show that the new method is not only available for analyzing the combustion of traditional CI engines but also is more effective for identifying the multi-stage combustion in RCCI engines. For the increased pre-injection ratio (PR), as the start of first injection (SOI-I) and the start of second injection (SOI-II) advance, the AHR in Stage-I (Q-Stage-I) decreases, and the increased Q-Stage-III lead to the improved indicated thermal efficiency (ITE > 49 %). Meanwhile, methane (CH 4 ), non-methane hydrocarbon (NMHC) and carbon monoxide (CO) emissions can be reduced by more than 50 %, while nitrogen oxides (NOx) emissions increase. The impact significance of SOI-II on Q-Stage-I and Q-Stage-III is higher, their values are + 65.88 % and −51.04 %, respectively, and the Q-Stage-II is mainly controlled by SOI-I. The impact significance of Q-Stage-III on ITE is the highest about + 69.43 %. Q-Stage-I shows a higher positive correlation with CH 4 , NMHC and CO emissions although the proportion of Q-Stage-I is far smaller than that of Q-Stage-II and Q-Stage-III. Therefore, the simultaneous reduction of incomplete combustion products and NOx emission can be achieved by reasonably adjusting split injection parameters.

Impact of secondary fuel injector in various distance on direct injection diesel engine using acetylene-bio diesel in reactivity controlled compression ignition mode

Advancing RCCI engine performance via optimal acetylene premix ratios and advanced diesel injection timing: An experimental investigation

Effect of manifold injection of 1‐hexanol on a reactivity controlled compression ignition engine fuelled with neem oil methyl ester blend

Effect of Fuel Injection Pressure and Premixed Ratio on Mineral Diesel-Methanol Fueled Reactivity Controlled Compression Ignition Mode Combustion Engine

Investigations on reactivity controlled compression ignition combustion with different injection strategies using alternative fuels produced from waste resources

Enhancing reactivity-controlled compression ignition engine performance: A response surface methodology approach with ammonium hydroxide-waste cooking oil biodiesel optimization

The Experimental Investigation of the Effects on the Combustion, Performance, and Emission Characteristics of an RCCI Engine Using Methanol/Diesel Fuel

Predicting the effects of direct-injected fuels co-powered by high-CO2 biogas on RCCI engine emissions using kinetic mechanisms and multi-objective optimization

Experimental Study on Combustion Characteristics of a Fischer‐tropsch Diesel/methanol Reactivity Controlled Compression Ignition Mode Engine

Impact of injection pressure on a dual-fuel engine using acetylene gas and microalgae blends of chlorella protothecoides

Analysis of CRDI diesel engine characteristics operated on dual fuel mode fueled with biodiesel-hydrogen enriched producer gas under the single and multi-injection scheme

Numerical Study on Double Injection Techniques in a Gasoline and Biodiesel Fueled RCCI (reactivity Controlled Compression Ignition) Engine

Influence of injection strategies on ignition patterns of RCCI combustion engine fuelled with hydrogen enriched natural gas

Particulate Matter Emission Characteristics of a Reactivity Controlled Compression Ignition Engine Fueled with Biogas/diesel Dual Fuel

Experimental study on reduction of pollutant emissions in reactivity controlled compression ignition (RCCI) engine fueled with diesel/gasoline fuels

A Comprehensive Study of Fuel Reactivity on Reactivity Controlled Compression Ignition Engine: Based on Gasoline and Diesel Surrogates

Numerical Investigation on the Effect of Reactivity Gradient in an RCCI Engine Fueled with Gasoline and Diesel

Impact of engine control variables on low load combustion efficiency and exhaust emissions of a methane-diesel dual fuel engine

Potential for Reducing Emissions in Reactivity-Controlled Compression Ignition Engines by Fueling Syngas and Diesel

Effect of split injection strategy of diesel fuel on multi-stage heat release and performance of a RCCI engine fueled with diesel and natural gas

An integrated effort of medium reactivity fuel, in-cylinder, and after-treatment strategies to demonstrate potential reduction in challenging emissions of reactivity controlled compression ignition combustion